Magnetic LED Tow Light Kit - Weatherproof - Red Lens - 20' Wiring Harness - Qty 2

See what our Experts say about this Optronics Tow Bar Wiring

• Lighting Options for Flat-Towing 1997 Jeep Wrangler With a Truck
  There are several options for lighting kits to allow flat-towing a vehicle. These range from the easiest-to-install and remove magnetic types, to independent bulb-and-socket kits that bypass the dinghy's wiring to hard-wired diode kits that require cutting into the dinghy's wiring. For ease of installation the magnetic type will be preferred as these require no alternation of the towed vehicle; they are also a cost-effective option. For example, Optronics offers their # TLL21RK 20-Foot...
  view full answer...
• How Strong Are The Magnets On The Optronics Magnetic LED Tow Light Kit?
  Optronics does not have a weight rating for their Magnetic LED Tow Light Kit # TLL21RK, however, this magnet is very strong and has been road tested at high speeds in varying weather conditions. This product is also made from durable polycarbonate, and is sonically sealed to waterproof the lens and housing from weather damage.
  view full answer...
• Recommended Temporary Brake Lights For 10 Foot Box Truck
  I recommend to use Magnetic LED Tow Light Kit - Weatherproof - Red Lens - 20' Wiring Harness part # TLL21RK which plugs into a 4-way connector on the truck. The lights will act as running, brake lights and turn signals once plugged in. However, they are designed for flat towing a vehicle so you may consider checking into the laws of your state before using these on the box truck just to be safe. If you do not have a 4-way connector please let me know the year make and model of the truck...
  view full answer...
• Why Can Optronics Magnetic Tow Lights Only be Used with Vehicles Under 80 Inches
  There are certain lighting requirements for vehicles or trailers that are over 80 inches wide that magnetic lights such as # TLL21RK cannot provide. You would need front and rear clearance lamps that are mounted at a 45 degree angle (PC rated). So if the back of the vehicle was a square for example, the light would be at the corner pointed half way between the side and the rear of the vehicle. They need to be placed as high as possible. You also need rear identification lamps (3) centered...
  view full answer...
• Both Turn Signals Blink on MaxxTow Tow Lights # MT70097 When Tow Vehicle Signals Are On
  If both the left and right turn signals on your MaxxTow Tow Lights MT70097 blink when either turn signal is activated on the tow vehicle the first thing to check is the condition of both connectors. Since the left- and right-turn signal circuits on a 4-pole are adjacent to each other (green and yellow wires), it is possible that corrosion in the connector can cause these two separate circuits to become bridged together. This condition could also explain the dim light output, since two...
  view full answer...
• LED Tow Bar Lighting Kit that Could be Used on Trailer or Flat Towed Vehicle
  Sounds like you are looking for a set of LED magnetic tow lights like the part # TLL21RK that you referenced. This is only way to add temporary lights to a trailer or flat towed vehicle like you mentioned and is LED like you want as well.
  view full answer...
• Recommended Magnetic Towing Lights For 2015 Volkswagen GTI On Tow Dolly
  I recommend using magnetic lights like part # TLL21RK. These have a 4-way harness and since these have red LEDs you have much less current draw than using incandescent. These lights have a 20 ft long harness and also a 4-way connector.
  view full answer...
• Portable LED Lights with 4-Pole Connection
  Optronics LED Combination Tail Light Kit # TLL9RK has lights that use a separate white ground wire that normally would ground to the trailer. Then the trailer 4-pole wiring would in turn carry that ground back to the tow vehicle via its 4-pole wiring. One way or another these lights' ground must connect to the vehicle's ground. There is an easier solution for temporary lighting, a portable LED light kit like # TLL21RK. This kit includes two magnetic-base lights with a prewired 4-pole with...
  view full answer...
• Available Magnetic Type Tow Lights for Flat Towed Vehicle
  Stop, turn and tail light functions can be provided by basic 4-pole wiring, such as by the trailer wiring harness # 118552 that fits your 2014 Patriot or a flat towing (dinghy) harness that connects the RV lighting signals to the dinghy. If you are looking to add the cargo box lights as supplements to your standard flat tow lighting you will want to consider a few things. First, additional lights will demand more power and so I suggest using high-efficiency LED type lights that will be...
  view full answer...
• Recommended Flat Towing Removable Light Kit for Jeep and RV with 4 way Flat Connector
  We are absolutely here to help in these types of situations! Using something like the Magnetic LED Tow Lights # TLL21RK would bypass any of the vehicle lighting completely and give you a set of tow lights that are easy to remove when not in use. This will plug into a 4 way flat on your RV, or if you've got a 7 way connector you can use the Hopkins Heavy-Duty Trailer Coiled Wire Adapter for 7-Way to 4-Wire Flat # HM47065 you mentioned. When it comes to the brake lights not working on...
  view full answer...
• Can a 2015 Toyota Camry Be Dolly Towed?
  According to the owners manual for your 2015 Toyota Camry it can be pulled by a Tow Dolly # DM9713093 with the front wheels off the ground in an emergency situation. The only specification was to release the parking brake so your transmission can be left in park. Be sure to verify the laws where you will be towing as you may need a Tow Light Kit # TLL21RK to remain legal.
  view full answer...
• Interference Between Wireless Magnetic Tow Lights and Portable Proportional Braking System
  I spoke with my contact at Roadmaster and he said if you are using wireless magnetic tow lights like # NV-5164, or any other wireless device or product, there is a good chance you will get feedback or interference with the Roadmaster Even Brake Portable Proportional Braking System # RM-9400. The interference can cause false readings or false signals, therefore wireless magnetic tow lights are not recommended. As an alternative you can use a magnetic tow light set which plugs into your...
  view full answer...
• Lighting Options for 2016 Lincoln MKX that Is Flat-Towed Behind Motorhome
  It sounds like you need a flat-towing wiring harness to allow your motorhome to control the lights on the towed MKX. There are several options for flat-towing lighting and these vary in cost, complexity of installation and in how permanent that installation is. With a brand new vehicle like your MKX you can consider a set of magnetic lights like # TLL21RK, which uses a 4-pole flat type connector. This kind of lighting kit means you do not have to cut into the brand new car's wiring or...
  view full answer...
• Is the E-Z Mount Tow Light Kit EZT20B Still Available
  The E-Z Mount Tow Light Kit part EZT20B has been discontinued by the manufacturer and replaced with the magnetic base style, the Magnetic Towing Light Kit part # RM-2120. I did check all of our other options but none retain this same style of mounting. The list is attached below as well.
  view full answer...
• 4-Pole Light Kit for Use with Tow Dolly
  If you need to tow your Prius on a tow dolly that does not include built-in lighting then you can easily use a set of magnetic tow lights such as # TLL21RK or # TL21RK. Both these use a 4-pole flat type trailer connector. The Roadmaster tow dolly # RM-2050-1 has built-in lights.
  view full answer...
• Portable Magnetic Lights Recommendation For Trailer
  We do offer some magnetic lights that may work well for you. I recommend the Optronics Magnetic Tow Lights, part # TLL21RK. These have red lights which act as running lights, brake lights and turn signals. These lights have LEDs which have increased brightness and draw less power. These magnetic lights come with a 20 ft long wiring harness and the 4-way plugs.
  view full answer...
• Do Vehicle Taillights Need to Function If Vehicle is Towed with Tow Dolly
  Generally, you don't need additional lighting when using a tow dolly that already has lights. However, it's not a bad idea to check with the local laws in the states you'll be traveling in. If you do need to have lights on the vehicle you could use the magnetic LED tow light kit part # TLL21RK and to add a 4-way to your tow vehicle's wiring you would want the part # 18252 which would wire into the current trailer wiring.
  view full answer...
• Flat Towing Wiring Harness for 2010 Chrysler Town and Country Limited
  The options for wiring/lighting kits for towing the van behind your Beaver motor coach can be seen by clicking on the link provided. The Beaver website does not include wiring diagrams for its Class A, B, C or 5th wheel RVs but I was able to find a wiring diagram for the van by doing a Google search on the phrase '2010 Chrysler Tow and Country wiring diagram'. This may well also appear in your owner's manual. These choices include diode kits like the Roadmaster # 154-792-118158 and magnetic...
  view full answer...
• Which Tow Bar Light Kit for Flat-Towing 2011GMC Acadia
  The RoadMaster Bulb and Socket Set for Tail Light Wiring Kits, part # RM-155-2, is not compatible with your Acadia lighting system. These incandescent bulbs will not fit in your tail light housing due to the presence of the circuit board that powers the Acadia's LED lights. Also, they would generate much more heat than the specified LED bulbs and might interfere with the nearby circuitry. If you will be towing your vehicle only on occasion, you may want to consider a magnetic towing light...
  view full answer...
• Adapting 6-Pole Square RV Connector to 4-Pole Flat Connector for Use With Optronics Lights # TLL21RK
  There is no plug-in adapter available to mate a 6-pole square RV connector directly to a 4-pole flat connector, but we do offer a 6-Pole Square Trailer Wiring Connector Kit, part # 37995, that can work for you as long as you do not have a Jayco RV (which can have compatibility issues with this part). Hopkins Connector Kit # 37995 includes both male and female connectors. You can cut off the 4-pole flat connector from the MaxxTow Magnetic Light Kit and splice in the male 6-pole connector...
  view full answer...
  
• Tow Bar Wiring Options for 2015 Chevrolet Malibu
  Since this is a universal-fit kit it will work on multiple vehicles; it will work on your 2015 Malibu. Different light styles between the 2012 and 2015 model year Chevrolet Malibu mean this harness will not fit a 2012 Malibu but it will fit your 2015, the Roadmaster 6-Diode Universal Wiring Kit # 154-792-118158. If you prefer a simpler tow bar lighting option you can instead go with easy-to-install magnetic tow lights such as the Optronics # TLL21RK. These require no modifications to your...
  view full answer...
• Tail Lights Covered By Bike Rack Solution
  The lights on the Demco Tow Lights w/ Wiring Harness # DMKKLB do not adjust from the vertical 180° position. The feet on # DMKKLB do adjust positions left and right for different angles. I recommend using the Roadmaster Standard Magnetic Tow Lights # RM-2120 to alleviate your blocked tail lights. The harness plugs into your 4 way flat trailer harness and uses magnetism to secure to the back of your vehicle. If you have nothing for the magnets to stick too, you can use # 3378895404 to fix...
  view full answer...
• Tow Bar Lighting/Wiring Options for Flat-Towing a 1994 Jeep Wrangler
  The Roadmaster Universal Hy-Power Diode Wiring Kit you referenced, part # RM-154, will work on your 1994 Jeep Wrangler. This kit includes the 4-pole connectors, diodes and wiring components for installation that will allow your Wrangler tail light bulbs to operate in tandem with your RV. This is a great option for frequent flat-towing. I have linked an install video for your reference. A simpler option, and one that does not require any alteration to your toad wiring, is to use a plug-in...
  view full answer...
• Tail Lights for Motorcycle Carrier that Blocks Tow Vehicles Lights
  If a motorcycle on a hitch mounted carrier is blocking your vehicle's tail lights and turn signals then it will be illegal to use in day or night. If you have a 4-way trailer connector you can use a cargo carrier light kit, like # e98943-44LED. These are designed to be installed on a cargo carrier but they'll work for your application. You'll need to find a way to mount them though. Another option is a magnetic light kit. The Magnetic LED Tow Lights # TLL21RK plug into the vehicle's...
  view full answer...

Do you have a question about this Tow Bar Wiring?