This transfer switch automatically changes from shore power to generator power when needed. Protects your electrical system from AC power backfeed.
Features:
Specs:
Furrion's transfer switch is wired to automatically change the primary source of AC current from shore power or an inverter to a generator when available. So, in the case that you unexpectedly lose shore power, the switch will automatically begin to run power to your RV's appliances from your generator.
The switch between power sources is seamless to the point that you won't even notice the difference in power being sent to your appliances and electronics. The 50-amp single pole switch provides 120V or 250V AC. To prevent electrical interruptions or damage to the system, the time delay function utilizes a 20-30 second window to switch between power sources. This protects against dangerous backfeed, and keeps the voltage from each power source from being active at the same time.
The time delay function features a bypass switch for inverter power. Since an inverter doesn't need time to warm up like a generator does, you can bypass the time delay for instant transfer from shore power to inverter power.
The plastic case has 15 punch-out holes which allow you to arrange the cables and wiring in whatever way is best for your setup. The included user manual lays out 3 typical setups for you.
The switch wires to your shore power input and generator or inverter input. Both inputs are wired to the AC panel.
Average Customer Rating: 4.8 out of 5 stars (97 Customer Reviews)
This transfer switch automatically changes from shore power to generator power when needed. Protects your electrical system from AC power backfeed.
You are great people to work with
Nice product, packaged well and arrived in xlnt condition.
Thank you
Works flawlessly. I bought two for some complex switching.
Nice product and speedy service !
It works like a charm. When the electricity goes out it automatically switches over.
Very easy to install, well made.
This replaced the old Magnatek ATS quite well. It took about an hour total to swap it out. I like the delay chip that you can switch on if one of your sources is a generator. It lets the generator run for 20-3 0 seconds before switching over. Great item and works exactly as described.
Works great!
It works, but takes almost a minute after power is turned on for.it to switch and energize the panel.
This unit fixed my problem.
Great, just need to find out if the regular 30 amp hook up will work instead of generator hook up with this transfer switch. Want to put hook up in front of trailer along with original rear power connection.
So far so good. Several trips and camping off grid.
Good performance!
The switch works very well and has functioned flawlessly in the last year, we've been traveling across the US and Canada.
But, the plastic cover has small plastic tabs, and one of them broke off so now the cover is not sitting securely and I had to use some duct tape. I think a better design would have had screws in the four corners of the cover
Do you have a question about this RV Transfer Switch?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.