Your propane cylinder and regulator need a hose between them. This 12" high-pressure pigtail connects a POL cylinder valve to a regulator with a 1/4" female IF inlet, supplying propane to your RV system.
When your propane cylinder sits close to your RV regulator, this 12" hose makes the connection without leaving excess hose length. The hard nose POL fitting tightens onto the cylinder valve with a wrench, and the 1/4" male IF connects to a compatible female regulator inlet.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone, Steve here with etrailer. Today we're taking a look at the MEC propane pigtail hose. If you need to replace the high pressure hose between your propane cylinder and the RV regulator, one of the most important things is to check the connection on both ends. So this pigtail gives you a specific combination for systems that use a POL cylinder connection and an inverted flare regulator inlet. So start at the tank, you're going to have a male hard nose POL fitting with a 7/8th inch nut that threads into the internal POL connection on the propane cylinder. And unlike a hand tightened type one fitting, you just use a wrench to securely tighten that connection.
Now as you can see there on the screen, we also sell leak detection fluid separately. Highly recommend you pick up some of that as well. It's very needed. Anytime you reconnect any kind of propane fittings, I highly recommend you use that. Now on the other end, you're going to have a quarter inch male inverted flare.
So male end you're going to have the threads on the outside. And this will match up to your RV or camper's propane regulator. Make sure that that's the type of fitting that it uses and needs before you're ordering because we do sell these that look the same but have different size connections and different male versus female kind of connections. So make sure you check out before you order what you need. This is 12 inches long, so it's going to be great when your propane cylinder regulator are mounted pretty close together and you don't have a lot of extra room and you don't want extra long hoses that you have to coil up and those kind of things.
The hose itself is a thermoplastic, fully crimped brass ferrules on both ends. And since it carries propane directly to the cylinder, it's designed for high pressure service up to 350 PSI. It's also UL and CGA approved for propane use. That's going to wrap up our look together folks. Again, we carry these in multiple lengths.
If you need something longer, check it out separately here at etrailer. I'm Steven. Thanks for watching and have a great day.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.








Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.