Firestone Rear Air Spring, Tapered Sleeve, 1/4" NPT - Model 110/70

Video Transcript for Review of Firestone Vehicle Suspension - Replacement Tapered Sleeve Air Spring - F9002

Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at the Firestone tapered sleeve rear airs spring, and this is the Model 110/70 and that model number is stamped right on the side here of the spring. Now this is a replacement rear airs spring that works on the Firestone Sport-Rite kits, part number F2162, F2165, F2222, F2293, F2312, and the F2409. All those kits we do sell separately on our website. This is a standard taper sleeve air helper spring. This will give you maximum load support.

Provides a nice cushioning between the opposing components and it'll enhance performance and ride comfort on your vehicle. Does operate at up to a hundred psi. It is a four layer reinforcement construction. It enhances the air spring load support and it is environmentally friendly. It uses coated metal end plates to provide superior corrosion resistance.

Now at the very top here, they have a machine welded quarter inch NPT inflation port that your valve would screw into there. Now this is just for this sleeve. It does not include any of the parts to install this. Those items we separately on our website. This does use rolled crimp seals on the ends.

Helps keep the rubber airbags secured to the end plates. This is for a quantity of one rear air spring. It does have 1500 pounds at a hundred psi per air springing capacity. Maximum diameter, the top here is gonna be 5.7 inches. The extended height and the full amount this will extend in height, 9 1/4 inches, fully compressed 5 1/4 inches.

The right height, which is about what it is right now is about seven and a quarter inches tall. But that should do it for the review on this Firestone tapered sleeve rear air spring, model number 110/70.