Arrives before Christmas 
This replacement inner member slide fits into the existing outer member housing of your Dexter or Tie Down surge brake actuator. Fits actuator models LP80, LP85, and LP8500.
Features:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone. Steve here with etrailer.com. Today, we're looking at a replacement inner member for your Dexter Tie Down LP80, LP85, or LP8500 brake actuators. So folks, again, this is gonna replace a worn out or damaged inner slide member and assembly for those Dexter Tie Downs. As you can see, you get everything here included. It's gonna fit the two-inch ball.
The cable tie here and on the top are just holding in the plastic piece here that helps it slide in and out, so that's why I left them on. And then, of course, you got all your spring mechanism in here, and then the reservoir with the wire and the solenoid here for the reverse lockout and everything. You get another cap, all the bolts and hardware needed and spacers and safety pins. Everything you have here will be a direct replacement from Dexter, so you can be sure it works with those Dexter Tie Downs that I mentioned. And that's gonna wrap it up for our quick look together.
I'm Steven, thanks for watching.
Should have included the tiny ground wire screw. It did not. But other than that. A perfect match. Perfect fit.
Thank you!!!
Perfect fit
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.