Availability of Lighted License Plate Mount for Cargo Carrier

Question

Question:

I need a lighted license plate mount for a trail hitch rack. With a red brake light would be even better. thanks

asked by: David

0

Expert Reply:

If you have a hitch mounted cargo carrier like the Rola Swinging Hitch Mounted Cargo Carrier, part # 59109, that you reference, your license plate will attach to the bottom tray between the taillights. There are four mounting points to show where the license plate is supposed to go. There are also two mounting points to show where the Rola License Plate Light Kit, part # 59117, should be installed. This light comes only in white. However, the Rola Carrier has a plug for the red brake lights.

I have attached a video link to a demonstration of Rola Swinging Cargo Carrier.

I have also linked to our selection of cargo carrier brake lights if needed for a different carrier type.

expert reply by: Chris O

0

Answer 1

Hello Jim, thanks for reaching out. We do have a hitch mounted carrier that works great for mobility scooters. Take a look at the Erickson Aluminum Mobility / Cargo Carrier #EM34JV. This is made of aluminum so it is strong and lightweight. It has a…

view full answer...

Answer 2

Hey Richard, I was able to determine that your 2016 Tail Trailer model 03 – PST2000 has a 2,000 lb axle setup so the correct idler hub would be the part #AKIHUB-545-2-G-2K which has the 5 on 4-1/2 inch bolt pattern you need as well. The trailer…

view full answer...

Answer 3

I have a solution for you to hook up the Optronics LED Trailer License Plate Light w/ Bracket #LPL55CB to your 2021 Subaru Ascent without tapping into the wiring. You could install Hopkins Endurance Easy-Pull Harness w/ 4-Pole Flat Connector -…

view full answer...

Answer 4

Hey Tom, yes the Erickson Cargo Carrier part #EM34JV would work great for you as it has the needed clearance to fit past the rear of your RV as well as has the needed weight capacity.

view full answer...

Answer 5

Hey Linda, thanks for reaching out! Yes, the Erickson Aluminum Mobility / Cargo Carrier #EM34JV uses an M16 threaded bolt for the hitch pin. Are you looking to replace it, or are you trying to get on in advance? (This already comes with one)

view full answer...

Answer 6

Hey Manning, the etrailer hitch part #e98848 that you referenced does fit the hybrid models and also will allow the hands free liftgate to still function but you will need to kick to either side of the hitch opening. Then for trailer wiring you'd…

view full answer...

Answer 7

Hello Joseph, thanks for reaching out. We do have class 3 hitch options for your 2017 Honda CR-V. There are two options to consider. Both of there options bolt up to the frame, and would not require removal of the impact structure. The first is the…

view full answer...

Answer 8

Hi David; the good news is the EcoHitch Hidden Trailer Hitch Receiver #EH92KR does fit the hybrid model of the 2025 Kia Carnival. This has a concealed cross tube so you won't lose a lot of clearance and a bolt-on installation. If you're…

view full answer...

Answer 9

After installing The Rear View Safety Rear View Mirror with Monitor #RVS-718, per the manufacturer they state that there is more then likely a possible short within the camera. They recommend to check all the connections such as the ground, and make…

view full answer...

Availability of Lighted License Plate Mount for Cargo Carrier

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching