How Many Tubes of Sealant Are Recommended for Installing an RV Roof Vent

Question

Question:

How many tubes of lap sealant will I need to seal the fan and roof?

asked by: Jeff M

0

Expert Reply:

Hey Jeff!

We have the Roof Vent Installation Kit # 344270KITW which comes with 2 tubes of sealant, a roll of butyl tape, and screws to complete the installation. If you're just needing the tubes of sealant then you can find that as part # 34427034145-1.

I'm attaching a video where we use this installation kit for a roof vent so you can see our method for applying it.

expert reply by: Jon G

0

Answer 1

I do have a solution for you. Unfortunately, it will be by replacing the lock on your RV. The red lever on your RV lock is not replaceable. We do have many options to choose from. You can use something like the Global Link RV Entry Door Locking Latch…

view full answer...

Answer 2

No, you don't want to put Kilz down. The adhesive for the LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane item #344270KIT35 won't stick to the primer. It needs the bare wood. The item #344270KIT35 install kit comes with everything…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Hey Travis, we have the Air Lift LoadLifter 5000 kit part #AL47PD that is a confirmed fit for your 2021 Ford F-150 and also is compatible with in-bed hitches like your B and W Turnoverball Gooseneck part #BW77FR. What are you towing?

view full answer...

Answer 8

For your 2020 Ford F-150, you're going to need a set of tow bars, a braking system, wiring, and a base plate kit. For a base plate kit, I recommend going with the Roadmaster Crossbar-Style Base Plate Kit #RM-524431-4. This base plate creates a…

view full answer...

Answer 9

Hi Keith; you can use a hacksaw or any power tool designed for cutting metal to cut the #LC84FR down to size.

view full answer...

Answer 10

The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…

view full answer...

How Many Tubes of Sealant Are Recommended for Installing an RV Roof Vent

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching