Can I Bypass Lippert Stabilizer Jack Switch To Test Switch Functionality

Question

Question:

I believe my switch for Lippert stabilizer jack is bad. The jack went down but will not retract. It had gotten iffy in both directions over past couple of months but worked in both directions. Is there a way to splice the wires perhaps the red to the yellow to reverse the jack to bypass the switch and verify it is probably a bad switch?

asked by: Alan Z

0

Expert Reply:

To bypass the switch that came with the Lippert High-Speed Power Stabilizer Jack # LC298707 you can definitely grab the 12V power wire (red wire on switch) from your battery and apply it directly to the yellow "retract" wire to see if the motors operate just fine. You can also verify that the jacks themselves work just fine without power by using the manual crank # LC119226 if applying power to the "retract" function doesn't do anything.

If you find that the switch is the problem then you can replace it with part # LC387874. If applying power directly to the motors doesn't cut it then the correct replacement motor is part # LC352338.

Attached are some review videos for you to check out.

expert reply by: Jon G

0

Lippert Stabilizer Jack Wiring Diagram
(click to enlarge)

Lippert Stabilizer Jack Switch
(click to enlarge)

Answer 1

Is there any brand info elsewhere on the stabilizer jack?

view full answer...

Answer 2

To replace the motor on the Lippert Stabilizer Jacks for your 2012 Cougar Trailer, I recommend the Lippert Jack Motor #LC352338. This is designed to work with Lippert Rear Electric Stabilizer Jacks and is now 2 times faster than the original unit…

view full answer...

Answer 3

The part you are referring to is a circuit breaker, not a relay. In order to test the circuit breaker all you need to do is probe the blue wire that feeds this and then the red wire which is the output. If you get 12 volts on the red output wire…

view full answer...

Answer 4

No you cannot. The part #LC352338 is a stabilizer jack motor and the part #LC142178 is a landing gear jack motor and is therefore totally different. You have to stick with the #LC352338.

view full answer...

Answer 5

The Valterra RV Sewer Hose Carrier part #A04-5094BK could be used without the center support bracket. However, the bracket can actually be placed where you choose so it does not have to be in the direct center. This may then allow you to use the…

view full answer...

Answer 6

The Valterra RV Sewer Hose Carrier #A04-5094BK referenced in your question can be safely adjusted to a length of up to 94 inches. The tube has an outer diameter of 5 inches and will simply mount to the frame of your NorthTrail Trailer using the…

view full answer...

Answer 7

What's great about the Valterra RV Sewer Hose Carrier #A04-5094BK is that you can mount it in other places aside from just at the rear under the bumper. I attached a couple pictures that show it installed in a few other places that might give you…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Can I Bypass Lippert Stabilizer Jack Switch To Test Switch Functionality

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching