Replacement Trailer Taillight Recommendation for 2014 Yacht Club Aluminum Boat Trailer

Question

Question:

Hello, I have a 2014 Yacht Club aluminum trailer for a 20ft deck boat that has a busted tail light on the driver side. The only information I could garner from the light was that it was an Optronics A15TP2 which I could not find a match for that part number, Wondering if this light STL0017RB would be a correct replacement light? Thanks

asked by: Kevin M

1

Helpful Expert Reply:

I looked up pictures of your trailer and it uses the style of trailer taillight like the part # STL0017RB that you referenced so this would easily work well for you. Or if you prefer a style that has more diodes (22 instead of 1) we have the part # STL17RB.

expert reply by: Jameson C

1

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

view full answer...

Answer 7

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Replacement Trailer Taillight Recommendation for 2014 Yacht Club Aluminum Boat Trailer

Product Page this Question was Asked From

Continue Researching