What our customers are saying:
very easy to shop
Mike
Richmond, CA
Videos
for Truck Bed Mats
Help Articles
Expert Answers
I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine,…
To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…
The hub/drum you sent in a picture of is a Lippert 8,000 lb axle hub with an 8 on 6-1/2 inch bolt pattern designed for oil-bath applications. The correct replacement then is the #8-285-10UC3-A.
Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or…
The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…
It sounds like you are on the right track for tracking down where the issue is. That said, the integrated brake controllers they were putting in trucks around 2008 weren't as reliable as the ones they've been…
It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero…
I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system…
Hey Chris, Because the Thule TracRac TracONE Truck Bed Ladder Rack #TH27000XTB clamps to the lip of the bedrails it won't be compatible with any tonneau cover. You would need Thule's stake pocket mounted version the…
The Torklift Hitch Extension part #TLE1636 that you referenced can tow a trailer that weighs 6,700 lbs like you what you have but you would need to use a weight distribution system with it to have the needed capacity as without a WD system…
The 1-7/8 inch width is what is rounded up to 2 inches which is a standard width for winch straps. The 14 foot length is not something we carry. I recommend the Hand Winch Strap with Safety Hook, 2" Wide x 15' Long -…
The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…
Search For Custom Fit Ford F-150 Lightning AccessoriesSelect A Category Below
Towing
Ford F-150 Lightning BOLT brand vehicle and hitch locks
Cargo Control
Ford F-150 Lightning Roof Rack
Ford F-150 Lightning Tool Box
Ford F-150 Lightning Ladder Rack
Ford F-150 Lightning Truck Bed Extender
Ford F-150 Lightning Vehicle Cargo Control
Ford F-150 Lightning Truck Bed Sliding Tray
Ford F-150 Lightning Truck Bed Bike Rack
Performance Accessories
Ford F-150 Lightning Tire Chains
Ford F-150 Lightning Vehicle Sway Bars
Ford F-150 Lightning Salt Spreader
Vehicle Trim
Ford F-150 Lightning Floor Mats
Ford F-150 Lightning Tonneau Cover
Ford F-150 Lightning Nerf Bars - Running Boards
Ford F-150 Lightning Trim Kits
Ford F-150 Lightning Bug Shield
Ford F-150 Lightning Side Window Vents
Ford F-150 Lightning Truck Bed Mat
Ford F-150 Lightning Mud Flaps
Ford F-150 Lightning Windshield Wiper Blades
Ford F-150 Lightning Windshield Covers
Ford F-150 Lightning Vehicle Air Mattress