Videos
for Lexus ES 350 Owners
Help Articles
for Lexus ES 350 Owners
Expert Answers
for Lexus ES 350 Owners
To use a 7-pin with your 2014 Ford F-150, the first thing you will need to add is a 4-pin flat plug, #C56110. From there you would need to add Universal Installation Kit #ETBC7 and you're set.
view full answer...Hey Paul, so your 2024 motorhome built on a Ford Cutaway chassis does have a 7-way at the rear and brake controller install wiring under the dash so all you'd need is the part #TK99UR which comes with the P3 brake controller and the correct…
view full answer...Stabilizer straps are no longer required when using a Curt hitch like the #C13130; this was an older requirement for some Curt hitches when using a bike rack only, but they have since determined that it is not required or recommended any longer. You…
view full answer...For the 2016 Lexus ES 350 I recommend Draw-Tite trailer hitch #36530 for a few reasons. First, it is a Class II hitch which means you are not limited to carrying just 2 bikes like you would with Curt hitch #C11362. And second if you did use the Curt…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…
view full answer...Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…
view full answer...Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…
view full answer...Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
view full answer...It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
view full answer...
















