Custom Fit 2013 Toyota Tundra Accessories

Yes, you can! We've spoken to Curt about this exact issue before and we do have a solution. The Curt Hitch item #C15398 is designed for the 2013 Toyota Tundra's that come without a factory hitch. However, it will fit the…

To install the Tekonsha PowerTrac Brake Controller part #39523 in your 2013 Toyota Tundra with a factory 7-way all you need is the correct install harness, part #3040-P. This plugs into the connector found near your parking brake. To see how a…

In order to get the correct replacement seal you will want to remove the seal from your hub and get the number stamped on it. If you can't find the number you can also use the dimensions of your seal to get the correct replacement. Get the outer…

If the original seal had an inside diameter of 2.250, then that is the size I would stick with. The inside diameter is what rides on the spindle so you would not want to go with a smaller seal as you mentioned. We have two seals that have the 2.250…

We do not have this item in stock for me to measure its thread pitch but two of us estimated it as being 6 or 7 threads per inch. I linked a photo of the instructions to replace this part. The bearing is removable and is available as a replacement…

Thank you for the pictures! I took a look at what you have, and without knowing the exact dimensions of your switch I can't say for sure what switch will replace yours for sure, however I did find the: -Single Slide-Out Switch #37212285, which…

To carry lumber and tools with your 2023 Toyota Tacoma you are going to want the Thule TracRac TracONE Truck Bed Ladder Rack item #TH27000XTB-XK4B. This fits both the 5 foot beds and 6 foot beds with the deck rail system. The Thule ladder rack system…

The TruXedo Elevate Truck Bed Rack System #TX96NV has rails that add a mounting lip to be compatible with most inside-the-bedrail mounted tonneau covers like the BAKFlip MX4 Hard Tonneau Cover #BAK48329 you referenced. The issue people tend to run…

The seals that you would need to replace your AL-KO 1536852 seals are the TruRyde Grease / Oil Seals 10-10 (Pair) - Double Lip Seals #RG06-090. They have an inner diameter of 2.125", an outer diameter of 3.376", and are used for 5,200 lb -…

The Brophy D-Ring Tie Down Anchor - Bolt-On - 3-1/2" Wide - Surface Mount - 1,600 lbs #SR15-C are steel anchors with a zinc finish. Although the zinc finish will help avoid galvanic corrosion from dissimilar metals, the connection by drilling…

Yes, The Curt Trailer Hitch Receiver #C15398 is confirmed to fit your 2011 Toyota Tundra after you remove the factory installed hitch. The trailer hitch has a bolt on installation with no welding required. It has a black powder coat finish over a…

Is your trailer hitch a factory installed hitch? If so I am not sure why they would put that hitch on your 2007 Toyota Tundra since all configurations that have the 5.7 liter motor have a towing capacity that exceeds 500/5,000 pounds easily. If the…