Custom Fit 2013 Subaru Forester Accessories

The jacketed circuit is the ground. The one right next to that one is the tail light circuit, next to that one is the left turn circuit. And then the last one on the end is the right turn circuit. Check out the picture I attached to see the circuits…

Yes, I confirmed with Surco that the Clamp-On Adapter #SP1101 will fit your Surco Safari Rack 5.0 #S5072 on your factory rails on your 2013 Toyota 4Runner.

Setting up a trailer with electric drum brakes is going to be the easier and most cost effective way of adding brakes to your Scamp trailer. Since the trailer already has the mounting flanges that will limit the amount of parts and work that will…

Before you replace the OEM harness on your Forester you may want to check a few things. First, check the fuse for the trailer connector in the passenger compartment fuse panel. From my research the trailer connector fuse is in the number 1 slot. You…

I would discourage the use of an adapter for use of 2 inch accessories in 1-1/4 inch trailer hitch receivers. The reason is that the adapter places the carrier farther away from the rear of the vehicle and hitch, creating additional torque that 1-1/4…

The etrailer Trailer Hitch Receiver #e59AR will reduce the ground clearance on your 2013 Subaru Forester some, but it won't make the vehicle sit lower in the back. The only reason this will sit closer to the ground is because the receiver is the…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

I am not really sure what the dealership was referring to as a 22 axle but we do have options for you to lower your trailer. The first option if you have a leaf spring axle is an over/under kit like the Dexter Trailer Springs Over-Under Conversion…

Depending on how much you are looking to lower your trailer there are a few possible options. One option is to replace the ST205/75D15 tires currently on your trailer with the Westlake ST205/75R14 Radial Trailer Tire w/ 14" Silver Mod Wheel - 5…

In order to choose the correct replacement axle for a trailer you'll first want to start with the weight capacity. The weight capacity can be found on the axle tag in the center of the beam. Then, you'll need to measure the hub face (center…

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

The Thule Hullavator Pro, part #TH898, does in fact need crossbars that extend 4" - 8" beyond the feet. To use the flush rails on your 2021 Toyota RAV4, you will need a roof rack that has feet that are compatible with the rails. With those…