Videos
for Toyota RAV4 Owners
Help Articles
for Toyota RAV4 Owners
Expert Answers
for Toyota RAV4 Owners
What you can do to determine if the Yakima DoubleDown Ace #Y02451 will clear the rear spare of your 2009 Toyota Rav4 is take one measurement. Measure from the center of the hitch pin hole out to the furthest point out on your rear spare. If that…
view full answer...Quick connects like the Dutton-Lainson Electrical Quick Connects #DL24086 that you referenced do not have a release latch built into them. Basically you just slide them apart. They can sometimes be difficult to get apart, but if you wiggle them while…
view full answer...The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…
view full answer...Optronics doesn't offer instructions for the #TL29BK trailer taillight kit. However, if you click the link I provided to the the trailer wiring help article, you'll see a wiring diagram showing how the kit would be used to wire a trailer. The…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...You could technically install the MaxxFan Deluxe Roof Vent #MA00-07500K in the roof of your mini van.That being said, the main issue is going to be the mini van's roof thickness. Since the roofs on vehicles are significantly thinner than those…
view full answer...For as many units of the #288-06603 as we've sold, not one customer has reported any sort of damage to their vehicle door's weatherstripping. So, it's safe to say that unless you plan on leaving the cover on for months and months at a…
view full answer...The only hidden/concealed trailer hitch available for a 2010 Toyota RAV4 is the EcoHitch Hidden Trailer Hitch Receiver part #306-X7152 for models with spare tire storage on back and part #306-X7174 for models with spare tire storage underneath…
view full answer...The manufacturer of the axle should not be a issue if using an over/under kit. All you will need to know is the diameter of your trailer axle or axles. The Dexter over/Under Kits #K71-384-00 is for 2-3/8 inch diameter axles and #K71-385-00 is for 3…
view full answer...Yes, the Deter Trailer Springs Over-Under Conversion Kit #K71-384-00 will work just fine with your Lippert axles, the only thing you're going to need to check is that if the kit will fit your axle. For instance, #K71-384-00 will work with axles…
view full answer...I checked with Yakima and there is not a specific torque spec for the Replacement 2" Anti-Rattle Hitch Bolt Assembly for Yakima Bike Racks and DryDock Load Assist #Y8780022. So you'll just want to torque it until it is tight, and you can use…
view full answer...In order to determine if your 2011 Toyota Rav4 is able to be flat-towed you will need to consult the owners manual of your vehicle to see if there are any restrictions on flat-towing your vehicle. Some vehicles require an axle disconnect, drive line…
view full answer...