Custom Fit 2011 Chevrolet Silverado Accessories

The support braces in the HappiJac Truck-Mounted Camper Tie-Downs #LC182860 are going to attach to the cross frame to provide support for the anchors which will bolt through the bed wall and into the braces. The rear anchors will bolt through the…

You are a little on the warm side for your transmission fluid. If you can keep it under 200 degrees you will have the max life out of it. That being said transmissions really start to go downhill at 260 degrees. The Derale cooler part #D13503 with…

We sell replacement hitch install hardware for all of the hitches we offer like the #75521 which fits your 2011 Chevy Silverado with the part #RHK. This hitch does use Carriage Bolt 1/2-13 X 1-3/4 GR5 quantity of 4 as well as 4 of the Bolt M14 X 2.00…

Weight distribution spring bar tension can be increased by tilting the head toward the trailer so that the ends of the spring bars are closer to the ground. Once connected to the lift brackets this increased angle translates into more tension, which…

The best hitch I'd recommend for your 2011 Chevy Silverado is the Curt hitch part #14301 because it has great towing capacities at 10,000 lb trailer weight and because it has only the hitch tube that hangs below the rear bumper for a more…

Most of the time when a tow setup is porpoising with a weight distribution system all you have to do is add a bit more spring bar tension to minimize the porpoising. With an Equalizer system you would need to angle the spring bars down further to add…

According to section 9-85 of the owners manual for a 2011 Chevy/GMC Silverado/Sierra 2500HD the lowest capacity of any of the 4x4 models is 13,800 pounds. Consult your owners manual to confirm. Since the 5th wheel trailer you are looking at has a…

For your 2011 Silverado, I recommend the Hopkins Smart Hitch Backup Camera and Hitch Aligner System item #HM50002. This system mounts to the license plate bracket on the back of your truck. It features a 3-1/2" color monitor that will give you a…

If the recessed well that the gooseneck ball sits in is at least 15 x 15 inches square and no greater than 5 inches deep, then yes you can use the #RP85FR Reese Goose Ball 5th wheel to gooseneck hitch adapter. The #RP94720 model you'd looked at…

The number on the lens is not a part number. It is a rating for the lens/light. Based on that number it looks like the best match we have is #A31RB which is rated SAE AP2 86. The A in the number just means that it has a built-in reflector.

Your weight distribution system uses a Shank #FA92-02-4100 that gives you a maximum 6-1/4" of rise and 2-1/4" of drop. I recommend using the Fastway Shank #FA92-02-4214. This will give you up to 10" of rise and 7-1/4" of drop with…

Eight inches from the ground to the bottom of your weight distribution shank would be fine for most situations but like you've experienced turning into inclined driveways can cause it to drag. Your trailer must sit pretty low to call for your…