According to the owner's manual for your 2011 Chevrolet Avalanche, if you have the HD towing package and it is 2WD than your maximum towing capacity is 8,100 lbs but if you have the HD towing package and it is 4WD than your maximum towing…
For your 2011 Chevrolet Avalanche. I recommend the Timbren Rear Suspension Enhancement System, #TGMRYS4. The Timbren system will sit above the rear axle of your Avalanche and help stabilize and level your vehicle when under a towing load or hauling…
The pros and cons for the Air Lift air bag suspension enhancement kit part #AL60769 and the Timbren part #TGMRG25C is that the air bags are a bit higher maintenance since they require managing air pressure in them and you have to deal with the…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
The Timbren rear jounce spring kit you referenced, part #TGMRYS4, is a confirmed fit for the vehicle you indicated, a 2010 Chevy Tahoe, as well as several other GM vehicles noted on that item's page. Thank you for your photo that shows the…
Is it the additional spacers that are causing the main part of the spring to out of alignment compared to the stock bump stops on your 2004 GMC Yukon XL? Are the Timbren springs fully seated in the bump stop cups? On these vehicles it is hard to…
Most weight distribution spring bars are about the same length. Typically they are either 29 or 31 inches in length. The spring bars of the Curt #C17062 would be 30-5/8 inches, and the bars of the #PS49583 would be 31-1/4 inches.
What you have there is a Dutton Lainson jack. There is no longer a direct replacement jack, but you can use the #DL22580 which will be an upgrade. This is a swivel jack with a 1,500 lb capacity and 12" of lift. This has dual wheels for easy…
I reached out to my contact at Optronics and they were able to give me some additional information on this light set. The LED Combination Trailer Tail Lights #TLL16RK have full copper wires that are 18 gauge wires.
The wire gauge used in the LED Combination Trailer Tail Lights - Submersible part #TLL16RK is 20 gauge according to Optronics. This may seem light but the lights are LED and draw very little power. You can use Deka Heat Shrink Butt Connector - 22-18…
To remove the aerator in your Flow Max RV Kitchen Faucet #LC719324 you'll need to stick a small flat headed screwdriver into the small slots on the edges of the aerator to pry it out.
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…
