Custom Fit 2009 Toyota Highlander Accessories

I reached out to my contact at EcoHitch and she verified that the Hidden Trailer Hitch Receiver #306-X7137 will fit with the full size spare tire beneath your 2008 Toyota Highlander. You will want to lower/remove the spare during the installation…

In order to utilize the anti-rattle feature on the Kuat NV 2.0 2-Bike Platform Rack part #NV22G you'd indeed need to use a trailer hitch with longer receiver tube like the Curt Trailer Hitch Receiver part #13534. The EcoHitch Hidden Trailer Hitch…

Hey Jeremy, For stainless steel lug nuts I'd go with Lionshead's 1/2" -20 #LHLR103 or 9/16"-18 #LHLR110 depending on the diameter of your wheel studs. You could add in a hub cover but it's honestly not necessary and more so just…

Trailer brake controllers such as the Tekonsha Voyager #39510 are not vehicle-specific but the parts required to install one can be specific to a year/make/model vehicle. For instance, many pickups have a port under the dash to allow quick plug-in…

You'd want to use the 20 amp circuit breaker like #PK54220PL unless your trailer has more than two brake axles. If that's the case you'd want to use the 30 amp breaker #38630.

On a 7-Way connector the suggested minimum wire gauge for the White (ground) wire, the Red or Black (power) wire, and the Blue (brake power) wire is 12 gauge. The minimum wire gauge for the remaining Green (right turn/brake) wire, the Yellow (left…

Though it will depend on the hitch you have installed, all of the M10 bolts for the Draw-Tite #75726 and 75586 should be torqued to 42 lb-ft. The Curt #13534, which also uses M10 bolts, should be torqued to 48 lb-ft. If you installed an EcoHitch,…

The best trailer hitch we have for clearance on your 2013 Toyota Highlander is the EcoHitch Hidden Trailer Hitch Receiver #306-X7137 as it has a crosstube that sits behind the bumper so the only part below the bumper is the 2" hitch receiver…

The Curt Echo Mobile Trailer Brake Controller #C51180 gets its power from the 12 volt connection on the 7-way of your car, which is also outlined in the linked instructions. Please note that some vehicles may require a trailer to be connected in…

Your Toyota Highlander's factory wiring should include a converter found under the dash of your vehicle. It sounds like your trailer may have caused an issue with your converter. If this is the case, I recommend using the T-One Vehicle Wiring…

Other than the fact that the Curt #13534 uses a gloss powder coat finish and the etrailer.com brand #e98858 hitch uses a matte finish powder coat, there's no difference between the two hitches. Curt manufactures the etrailer.com brand hitches for…

For your 2008 Toyota Highlander we have an etrailer hitch that is a confirmed fit that allows you to keep your full size spare with the part #e98858 but the #e98901 that you referenced was designed for a different vehicle so it would not work for…