Installation: Tekonsha Prodigy P2 Trailer Brake Controller on a 2012 Ford Van Video

If your 2014 Ford E-350 Van came with a factory installed 7-Way trailer connector then all you would need is the brake controller and the wiring harness. The harness you referenced, #3034-P, is correct for your van and Tekonsha brake controllers such…

Hello Carla, We have the perfect fit for you, the Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center - Custom Fit - Class V - 2" #41945 is confirmed to fit your E-450 RV Cutaway. You will need to remove the back step in order to have a…

It looks like you have found the factory plug on your 2012 Ford E-350 that is used for installing a 4-Way Trailer Wiring Harness like the Hopkins #HM11140665. This port is found underneath the van at the rear, inside the driver's side frame rail.…

For your 2012 Ford E350 Van, the factory tow package came with either the 4-way or the 7-way. If you had the factory 4-way, then you would need to add the #ETBC7 for the brake controller wiring. The power wire to the brake controller is needed on…

In order to install a 7-way trailer connector and brake controller on a 2012 Ford F-150 you will first want to start with a 4-way trailer connector, the Replacement OEM Wiring Harness for Ford F-150 part #C56110 which is plug and play. Once we have…

Some 2012 Ford E series vans will have a factory plug and some will not. If your van came with a factory trailer connector then the wiring is already there and active. But if it did not come from the factory with a trailer connector, the factory…

The connectors you have found are not confirmed to be for the trailer wiring and we don't have any wiring harness that is a fit for what you described. Because you don't have the factory trailer wiring, I recommend starting with the T-One…

It sounds like your 2011 Ford E-250 is equipped with the towing package that Ford designates as the Class I tow package for the van. In this case there is a connector for the 16-pin plug on the harness but not for the 4-pin. If this is what you have,…

Hey Paul, so your 2024 motorhome built on a Ford Cutaway chassis does have a 7-way at the rear and brake controller install wiring under the dash so all you'd need is the part #TK99UR which comes with the P3 brake controller and the correct…

We can help you with a 4-pole flat trailer wiring harness for your 2012 Ford E-350 van. All types of wiring kits are shown on the linked page. These include products for vans equipped with no factory wiring, vans with a factory 4-pole set-up and vans…

There are 3 options from the manufacturer for the 2009 E-350 Ford Van. Factory 7-Way trailer wiring, factory 4-Way trailer wiring, and no existing trailer wiring. I will go over all three since you did not indicate which one your vehicle has. If you…

I suppose if you know how to rig that up you could just install a tee but expect the psi to drop when you use the air horn. The danger in running your air bags to an upfitter switch in the cab though is that you will be "flying blind" when…