Trunk Bike Racks Specs:
Features:
...Trunk-mounted rack carries 2 bikes on the back of your sedan, hatchback, or van Not compatible with most spoilers Anti-sway cradles with ratcheting straps hold bike frames at 3 points...
Installation Notes:
Place lower rack feet into license plate well
Do not open trunk while rack is installed
More Information >Trunk Bike Racks Specs:
Features:
...Trunk-mounted rack carries up to 3 bikes on the back of your vehicle Sturdy cradles with soft rubber straps secure bikes to rack Rotate to better fit bikes of varying sizes Slide along arms...
Installation Notes:
For proper installation, the lower pads should be located on the license plate of your vehicle.
Use the bottom of the hatchback door to attach lower straps or hooks.
More Information >Trunk Bike Racks Specs:
Features:
This trunk-mounted rack is an excellent, entry-level option for carrying 1 bike on your sedan, hatchback, or van. It has no moving parts so it's easy to set up right out of the box, and you can remove it quickly for storage in your vehicle.
Installation Notes:
Do not open trunk while rack is installed
Bike may contact the vehicle. Pad as needed. Recommended part is SA2060
More Information >Trunk Bike Racks Specs:
Features:
...Trunk-mounted rack carries 3 bikes on the back of your sedan, hatchback, or van Not compatible with most spoilers Anti-sway cradles with ratcheting straps hold bike frames at 3 points...
Installation Notes:
The flat part of the foot must sit against the vertical surface of the trunk and the toe rests within one inch of the bumper
Tech Tip:
2 bike/ 70 lb load limit. Bikes must be located in positions closest to the vehicle.
More Information >Videos
for Trunk Bike Racks
Help Articles
for Trunk Bike Racks
Expert Answers
for Trunk Bike Racks
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity…
view full answer...The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…
view full answer...I&…
view full answer...You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…
view full answer...Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what…
view full answer...It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…
view full answer...A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…
view full answer...The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the…
view full answer...I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…
view full answer...The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it…
view full answer...Filter Products (8)
Contact and Help
What our customers are saying:
Received already. Yeow! Perfect fit. Thanks for getting the kit to me so quickly.
Rich
Arlington, TX