2015 Toyota Tacoma Truck Tailgate Lock

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

I checked with Pop & Lock for you and there is a system that they have confirmed will work with 2011 and newer Leer 100XL, Leer 100XQ, and Leer 700: - Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers…

The manual switch for the Pace Edwards Bedlocker Retractable Hard Tonneau Cover #PE44CV can be found as part #311-BL-1120 on our site. This plugs into the harness at the canister and then you route and install the switch wherever it works best for…

The Leer 100XR isn't specifically listed by Pop and Lock but more than likely the #PAL9772 will fit. It requires a frameless, bonded glass door with a 1-1/8" center hole for a rotary latch. This particular kit would upgrade your…

As long as the rotary latch on your Leer topper has a 1-1/8" center opening then the Pop & Lock Power Lock Conversion Kit part #PAL9772 will work well for you. This unit will turn the existing manual handle on your topper into a…

The Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 will work on the A.R.E. MX series truck cap you referenced on your 2017 Ford F-250 Crew Cab Short Bed. This will give you a clean look along with the…

Pop and Lock does have the manual locking tailgate handle, #PAL5500, that will work with your 2015 Toyota Tacoma with backup camera. You can turn it into a power locking handle by adding conversion kit #PAL8525.

I do have an option for you to get the locks working again but we don't carry Load Lock so I don't have any advice or replacement parts for this. That said, you should be able to pretty easily replace this with the Pop & Lock Power Lock…

The Bauer Products T-Handle Lock for Truck Caps #BA57VR comes with a J-327 key. So by ordering 3 of these they are all keyed alike. This particular handle is for locks rotating counterclockwise. We also have the Clockwise T-Handle #BA84VR if your…

So long as you have the Leer 100XC truck cap, the correct Pop & Lock is the following: - Pop & Lock Power Lock Conversion Kit #PAL9772 I verified this with the manufacturer for you.

According to Pop & Lock, the #PAL9772 should work on a Leer 700 truck topper with the existing handle. If for some reason the handle isn't working, you can swap out to a new handle that will work with your Pop & Lock system using the…

The conversion kit you are talking about would be the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772. I checked with Pop and Lock though, and according to them the #PAL9772 is for 2011 and up model year Leer…