2014 Ram 2500 Tailgate

I do have an option for you but the Stromberg Carlson 4000 Series 5th Wheel Louvered Tailgate part #VGD-10-4000 does not have a spot for the factory backup camera. Therefore you would either need to find a way to mount this yourself, go without, or…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

Most manufacturers are in the process of discontinuing their fifth wheel tailgates with the camera relocation kits due to mechanical issues. Therefore I could not find one that fits your 2017 Ford F-350 Super Duty. The Stromberg Carlson 4000 Series…

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you don't…

Hi Chad! There are 2 ways to tell the difference between driver side and passenger side Dexter Axle brake assemblies; the first is by looking at the sticker on the inside, and the second is by looking at the brake assemblies as a whole. For example,…

From what I have found, the ALKO hub and drum assembly you have is for 7,000 lb axles. I believe the Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 12" - 8 on 6-1/2 #8-219-4UC3 will work as a replacement. This has the same…

Yes, the Dexter E-Z Flex Suspension Kit #K71-657-00 is the correct kit to upgrade your triple axle trailer which currently utilizes the 13-126 equalizer. Both these are designed for axle spacings 35" apart.

The Replacement Tailgate Top Seal for Pace Edwards Retractable Tonneau Covers #PE99CV does not come with great instructions. In order to install the Replacement Tailgate Top Seal for Pace Edwards Retractable Tonneau Covers #PE99CV, you will need to…

Most pintle hooks use a standard bolt pattern which is 3-3/8" horizontally center to center and 1-3/4" vertically center to center (see photo). Therefore, the Pintle Hook part #C48231 would be a direct fit and work well for you. It also…

Feel free to send me an email of your setup. But if you can mount the Rack'em Double Barrel Trailer Tailgate Assist #RA-27C 10 to 15 inches higher than the floor the ramp is attached to this should work well for you since it has a 200 lb…

For a 5th Wheel Tailgate like #VGD-10-4000, I recommend the Rear View Safety Backup Camera System with Flush Mount Camera #RVS-7707721 or the Rear View Safety Backup Camera System - Mirror with Monitor #RVS-772718 with this same camera. This is one…

When installed on your 2000 Ford F-250 7.3L Diesel Engine, the Edge Evolution CTS3 Performance Tuner #EP96TR that you referenced will give you up to 120 horse power and 315 ft lbs of torque. This tuner will plug right into the truck's OBD-II port…