Ramp Assist Recommendation for a 60 lb Ramp
Published 06/04/2015
Question:
I am in need of a ramp assist but not sure if it will work for my application. This is actually a material elevator, the ramp weighs approx. 60 lbs. and the amount of dead pull is about 40lbs. I would like to send a photo, so you can understand what I have,
asked by: Don
Expert Reply:
Feel free to send me an email of your setup. But if you can mount the Rack'em Double Barrel Trailer Tailgate Assist # RA-27C 10 to 15 inches higher than the floor the ramp is attached to this should work well for you since it has a 200 lb capacity.
I attached an install video for you to check out as well.
Product Page this Question was Asked From
Rack'Em Double Barrel Utility Trailer Tailgate Lift Assist w/ Chain - 200 lbs
- Lift Supports
- Trailer
- Tailgate Assist
- Steel
- RackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can the Gorilla-Lift Utility Trailer Tailgate Lift Assist Be Installed On a Trailer With Tall Sides
- Q&A: Will The Curt Hitch C22RJ Fit A 2026 Hyundai Palisade Hybrid?
- Q&A: Comparison Between Rack'Em Double Barrel and Gorilla-Lift Tailgate Lift Assist Systems
- Q&A: Looking for Furrion RV 30 Amp Power Inlet
- Q&A: How to Make Raising and Lowering a Heavy Trailer Ramp Easier
- Q&A: Comparing The Gorilla-Lift And Rack'Em Tailgate Lift-Assists
- Q&A: Brake Controller Plug Location on 2021 Jeep Grand Cherokee
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Install E-Track in 3 Easy Steps
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers