2004 Jeep Liberty Spare Tire Bike Racks

You can install a Yakima SpareRide 2 Bike Rack - Spare Tire Mount - Folding Arms #Y02599 on a 2020 Jeep Wrangler JLU, but it's likely going to interfere with the backup camera. There are relocation kits available for this but…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The best hitch for your 2023 Jeep Wrangler is the Curt Trailer Hitch item #C13392. This hitch is custom fit and bolts to your Jeep with included hardware. This is a class III hitch with a 2" receiver. It has a 3,500 lbs towing capacity, and…

To move the arms you just need to push up on the spring loaded bolts to release the arms and swing them into place. That will move the arm up and allow you to move it freely back and forth. When you release the end of the arm with the nut and…

The backing plate of the Surco Bike Rack part #BT300 that you referenced attaches to the rim by it sliding over the mounting plate for the wheel and then using the lug nuts that attach the wheel to the vehicle as a way to secure the wheel and the…

What you need is a light kit specifically for flat-towing. The Plug-N-Tow TM Vehicle Wiring Harness, #42615, would be if the Jeep were towing a trailer and not for activating its lights while it is being towed. There are a few options for lighting…

The good news is that I have an alternate option that will work on RV's. But the reason the Hollywood Racks SR1 2-Bike Carrier - Spare Tire Mount #HRSR1 is not rated for RV use is because that provides additional testing that is required.…

The Malone Hanger Spare Tire Carrier #MPG2147 will work on the spare tire of your daughter's 2021 Jeep Wrangler since the width of your factory spare tire is 9-1/2 inches wide. As far as bike frame adapters for the Malone Hanger, you will…

When installing any trailer hitch you would have to use all attachment points specified in the instructions. So if you wanted a higher capacity hitch like #13314 you would have to have that center tow loop welded back onto the vehicle. You will…

I do have a solution for your 2001 Honda CR-V, however using a 1-1/4" x 1-1/4" class I hitch may not be the best choice. Since you have a spare tire on the rear of your vehicle, you're going to need to use a hitch extender…

You would have to measure from your hitch pin hole out to the furthest point out on the rear spare of your 2007 Toyota RAV4 to determine if the #C18030 will clear it. The rack has a distance of 7-3/4 inches from the pin hole to nearest portion of…

The 1-1/4 inch part of the shank on Curt bike rack #C18030 is steel. The sleeve to adapt the rack to fit a 2 inch hitch is plastic. The other option would be to use a steel reducer sleeve in a 2 inch hitch, #HT02, and then not use the plastic…