2004 Chevrolet Blazer Spare Tire Bike Racks

To move the arms you just need to push up on the spring loaded bolts to release the arms and swing them into place. That will move the arm up and allow you to move it freely back and forth. When you release the end of the arm with the nut and…

The SumoSprings Solo Custom Helper Springs item #SSR-405-47 that fit a 2012 - 2023 Jeep Wrangler should have a 1/2" to an 1" of space between them and your axle.

Yes and no. The RockyMounts AfterParty Swing Away Bike Rack #RKY37ZR can be used if your bike has a smaller fender, but if it's a larger fender that covers most of the tire then it won't work as the clamps will damage the fenders.…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…

The backing plate of the Surco Bike Rack part #BT300 that you referenced attaches to the rim by it sliding over the mounting plate for the wheel and then using the lug nuts that attach the wheel to the vehicle as a way to secure the wheel and the…

For your 2018 Jeep JL Wrangler, I recommend using a weight distribution system, the Husky Center Line Weight Distribution part #HT32215 for 2" hitch ball or part #HT32216 for 2-5/16" hitch ball. The main reason I recommend a weight…

That is correct. If your 2021 Wrangler Unlimited has the connector located under the dash to the left of the steering column near the top of the e-brake pedal as shown in the provided photo, you'd use the #3073-P harness to connect the #90195…

I looked though the online version of the owner's manual for your 2018 Jeep JK Wrangler and there isn't a clear indication as to whether or not the key should be left in the ignition while it's being flat towed. There is a detailed…

The etrailer Invisible Base Plate Kit part #e98946 which is a fit for a 2005 Jeep Wrangler is designed for models with the factory front bumper. It actually attaches to the bottom of the bumper beam which you can see in the attached installation…

The good news is that I have an alternate option that will work on RV's. But the reason the Hollywood Racks SR1 2-Bike Carrier - Spare Tire Mount #HRSR1 is not rated for RV use is because that provides additional testing that is required. The…

The #MPG544 itself can handle 400 lbs of weight, but because an adapter/extender like the #MPG544 moves the load further away from the receiver tube it increases the leverage applied to the hitch. Because of that, using an adapter or extender will…