2013 Roadtrek RS-Adventurous Motorhome Spare Tire Cover

It sounds like the 2022 Chevy Silverado 3500 you are getting has the short bed. In that case, yes, you definitely want the sliding 5th wheel hitch for clearance. The good news is you will not need to purchase the entire B&W…

In order to replace the Advent Analog Wall Thermostat ACTH11 you'll need the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners part #ACRG15. This is a digital style replacement which is what…

For a pair of stabilizer jacks that would have more than enough capacity that would work well on your R-Pod I would recommend the Stromberg Carlson Trailer Scissor Jacks part #JSC-24. These have a 5k capacity per jack and would do a great job as…

Your 265/70R17 size tire is around 31-1/2 inches in diameter. You want to make sure the tire cover you get is large enough and doesn't have to be stretched over the tire. I'd rather have one that's slightly loose…

Yes, you can replace your GE air conditoner with an Advent air conditioner like the Advent Air RV Air Conditioner #ACM150. Additionally, you will also need a thermostat. For that, you can use the Air Distribution Box w/ Built-In Thermostat for…

Based on the information you gave, although I can't help with the axle (other than to state it is a 3,500 lbs axle). Dexter mobile home axles were designed for one time use and weren't really documented for replacement parts,…

The power circuit for each leg of the Lippert Ground Control leveling system #LC358590 is protected by a 35 amp fuse. That means that at most the entire unit could draw up to 140 amps at a time. Realistically it would probably be considerably less…

I trust regular axles with leaf spring suspension more than torsion axles only because I can see what is going on with the suspension and can fix any issues should they arise. With a torsion axle though there really isn't any maintenance…

There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…

Yep, you're exactly right; the distance from the center of the hitch pin hole to the welded gusset is indeed four inches on the Curt Ball Mount for 2" Hitches #C45112. So if that's the amount you need for it to…

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

If your step motor marked "REP 851" and the Part Number sticker says "32 Series Step," the replacement step motor kit you need is the Kwikee #LC379145 Motor Upgrade Kit. You can further confirm that…