Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The factory prep package or pucks are not the same between Ram, GM and Ford. The spacing is all different which means you cannot use a 5th wheel hitch for Ram pucks on a GM with pucks. Take the Curt A25 5th Wheel Trailer Hitch for example which is…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…
view full answer...You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…
view full answer...As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…
view full answer...Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…
view full answer...If the axles and suspension are currently in good shape replacing them won't necessarily gain you any additional ride quality. One great solution though if you are looking for a smoother ride quality is to convert the trailer to air ride with the…
view full answer...The best way to remove condensation from a cargo container like the etrailer.com Cargo Bag #988501 would be to use dessicant to remove the moisture in the air. A desiccant is a hygroscopic substance that creates or maintains a state of dryness.…
view full answer...Yes, and no. If you plan on using the Blue Ox Patriot Radio Frequency, Portable Braking System item #BLU37TR, you were looking at, you will also need the Roadmaster Brake-Lite Relay Kit for Towed Vehicles item #RM-88400. It will keep your…
view full answer...You are correct, the PT89ZR is only designed to measure up to 10A which will not allow you to measure for 4 or 6 brake magnets on a trailer. In this case I would recommend using a multimeter with a higher amperage rating or testing the magnets…
view full answer...Maximum amperage draw for 4 Brakes that are 10 or 12 inch diameter is 15.0 to 16.3 amps at 12 to 13 volts. The 14 gauge wire may be sufficient but for maximum braking effectiveness at full load capacity. I would opt to run 10 gauge wire. Larger wire…
view full answer...In order for a Rack Tamer mud flap to fit on a ball mount there has to be at least 1 inch of clearance on the shank. The B and W Stow and Tow Ball Mounts like part #BWTS20040B would have no problem allowing the Rock Tamer to fit. I attached a picture…
view full answer...Filters
- 3034 results