Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The biggest difference is the size of the ramps. The Flint Hill Goods #FHG23ZR ramps are 6' long and 14-1/2" wide for each ramp. The Stallion #288-07489 ramps are 65" long and 20-1/2" wide for each ramp. The Stallion ramps are only…
view full answer...To load your 1,000 lb golf cart in the back of your truck I recommend checking out the Arched Loading Ramp Set #288-07452-2 which will work for you so long as the height from your tailgate to the ground is no more than 35". These ramps have a…
view full answer...Yes, you can connect the ground wire to your trailer wiring and then the 12V power wire from the Ultra-Fab Electric A-Frame Jack #UF97FR to the 12V supply pin on your trailer 7-Way (11 o'clock pin when you're looking at the face of the…
view full answer...We don't have one that says anything that is compatible with a crank adjuster, but we do have the tube adapters you mentioned. If you have a round tube, I recommend the Gooseneck to Fifth Wheel Trailer Adapter #BD0289640300 which has a 4 inch…
view full answer...I can only recommend you go with the same amperage rating as what is called for in the install instructions of the Air Lift WirelessONE Compressor System for Air Helper Springs #AL25980 that you are installing. Since you want to use a circuit that…
view full answer...Based on my research, the Fulton Round, Snap-Ring Swivel Marine Jack #FTJ120W0301 will be a perfect replacement for your Shelby 5756A trailer jack. This jack will allow you to use the existing snap ring jack mount on your trailer for installation.…
view full answer...The Trailer Hub Assembly for 3,500 lb Axles, #84550BX, was confirmed by Dexter to be the assembly which replaced part 8-208, but please note that it does have a 5 on 5 bolt pattern, and you mentioned yours was a 5 on 4.5. To determine which bolt…
view full answer...The closest metric trailer tire size to a 4.80x12 is going to be a 145/80-12. The typical diameter of a 4.80x12 tire is 20.5 inches. On a 145/80-12, it is 21.3 inches. So the metric size will be a little over 1/4 inch taller. Make sure to measure the…
view full answer...Yes, the Thule Hullavator Pro Kayak Carrier part #TH898 will work with the Malone AirFlow2 Roof Rack either using the integrated channels or the wrap-around style clamps. However, the Hullavator requires that the crossbars extend at least 4"…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...I have another option for you, but due to the length of the ramp you would not want to use the Aluminum Car Hauler Ramp Set - 48" x 14-1/2" #288-07501 any higher than 12" as it could cause the ramp to not be secure and will be a pretty…
view full answer...Your Kubota L2501 weighs between 2425 to 2623 pounds so the Aluminum Car Hauler Ramp Set #288-07501 rated for 6,000 lbs will work well for the weight. You will simply need to determine if your loading height of your trailer will be over 12 inches as…
view full answer...Filters
- 86 results
Related Searches