Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Typically a trailer axle will have some camber in it - some bend - such that when it is not loaded the tops of the wheels bow outward slightly, with the outside edges of the tire treads making first contact with the ground. This allows that when…
view full answer...If your KZ Spree trailer's 3500-lb-rated axles are bent from damage or from overloading them beyond their weight capacity then they should be replaced. This will not only restore the trailer's handling but it will also prevent continued…
view full answer...If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…
view full answer...The torque rating for 1/2 inch u-bolts in U-Bolt Kit, #APUBR-1, is a minimum of 45 ft lbs and a maximum of 70 ft lbs.
view full answer...The brown wires on the axle #T3584F-8974 can be used to cross your electric brake power from one side to the other. You'll need to get power and ground from the trailer's 7-way to one brake assembly and then splice in the brown wires on the…
view full answer...Sounds like one of your shackles is facing the wrong direction after installing everything. When a shackle flips around and faces the wrong direction on trailer suspension most of the time just putting weight on the trailer and driving will correct…
view full answer...If your axles are already above the leaf springs the only way to increase the height of the trailer is to install taller hangers. You should note that this route isn't going to give you a dramatic lift. The biggest issue your setup has is the…
view full answer...I attached a picture that shows the proper position of shackles and equalizers on trailer suspension. Sometimes the shackle will flip up but if you jack up the trailer by the axle that's got the shackle flipped you can usually get it to flip back…
view full answer...If the shackles are flipping the wrong direction frequently that typically means the leaf springs are too short, the hanger spacing is too big, or the shackles are too short. Most of the time it's somebody changed leaf springs and just went with…
view full answer...Yes, the B&W Biker Bar Motorcycle Tie-Down System for Trailer #BWMC2303 was specifically designed to work on Harley Sportsters so it would work well on your 883I model.
view full answer...You want leaf spring shackles to be at a slight angle as that prevents the springs from flipping around to the other side of the equalizer over uneven terrain. I attached a picture that shows what the angle is typically like.
view full answer...Curt hitch ball #40038 has a 1 inch diameter shank. For Curt balls with 3/4 or 1 inch diameter shanks you would use wrench #C20001. The nut on that ball should use the 1-1/2 inch end of the wrench. You could also use a large crescent wrench if you…
view full answer...Filter Your Search
Contact and Help