Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Don, to install a 4-way to 7-way adapter like the part #37185 you don't have to run a wire to the battery unless you for sure need the 12 volt accessory circuit for like a trailer battery charge. Otherwise it is not needed for the taillight…
view full answer...Hey Bud. It doesn't say you can't put the Watchdog Power Center Surge Protector and Voltage Booster item #HU74ZR on its back but you are going to block some of the ventilation. The unit does warm up and it will shut off if the internal…
view full answer...Hey Marc, yes you can use the 50 amp Power Watchdog Surge Protector #HU82VR with a 30 amp power source. It will work just fine without any issues.
view full answer...The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...No, it does not. The Passenger Side K-Source Custom Extendable Towing Mirror item #KS62073G tilts in slightly to follow the contour of your Sierra 3500's A pillar. I attached a picture below so you can see it installed. It's slight but…
view full answer...Hey Brett, you have the largest Snapring tire cover size currently so what you would need is a larger size from a different brand like Adco with the part #290-3956 which is the next size up from what you have. Adco tire covers are really nice though.…
view full answer...The Yakima SkyBox 21 Rooftop Cargo Box part #Y07337 requires 57" of hatch clearance which is measured from the center of the front crossbar to the point where the hatch and roof meet. Unfortunately, there isn't anything you can do to…
view full answer...The front and rear Yakima JetStream Crossbars like #Y00426 should be level to each other on your 2017 Honda Pilot. Looking through the installation instructions for the BaseLine Towers #Y28TR and Fit Kit #Y00146 for your Honda Pilot, it does appear…
view full answer...According to the installation instructions for the Landing Pad 30 for Yakima SkyLine And Control Towers #Y25ZR, you will have to remove the flush mounted side rails to mount the landing pads. I do have another option for you that does not require the…
view full answer...All Yakima Skyboxes 2009 to current, like #Y95AV, feature SuperLatch security latches on both sides, so if one of your lock cores fell out, and you lost one of the lock cylinder housing components, the only solution is to replace the SuperLatch…
view full answer...I personally prefer the Thule WingBar Evo roof rack for your 2024 Kia Telluride. I prefer this system as it uses a 2 piece seal on the top channel which allows you to easily slide in your roof mounted channel accessories without requiring removal and…
view full answer...