Availability of Ball Mount for etrailer High-Low Adjustable Adapter

Question

Question:

Is there a compatible adapter with the hitch ball mount? Just like the shank. I know I can get my current hitch ball but that would have to go into the adjustable shank, so is there an adjust hitch ball mount for this assembly?

asked by: Michal

0

Expert Reply:

Hello Michal; are you asking if there is a hitch ball attachment for the etrailer High-Low Adjustable Adapter for Tow Bars # e52ZV? Even though this has a 2" receiver opening it is only designed for flat towing, not trailer towing, so you cannot use a ball mount with the adapter.

If you want an adjustable receiver it would have to be something like the Patriot Hitches 2" Adjustable Drop Hitch Adapter # PH38PR which is rated for trailer towing. You can add one of their ball mounts like the # PH34FV or just use a standard ball mount like # e27DR.

expert reply by: Robin H

0

etrailer High-Low Adjustable Adapter With Blue Ox Tow Bar
(click to enlarge)

Answer 1

Hi Jack, The Roadmaster Dual Hitch Receiver Adapter #RM23SR was designed to do exactly what mentioned - flat tow while also using a rack or cargo carrier of some kind. That said, it's important to note the #RM23SR has a 400 lb tongue weight…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hello Todd, great question. The Yakima EXO Swing Away and Gear Locker #Y62VR is going to allow you to open the rear doors on your 2025 Sprinter 3500XD RV at around 90 degrees. Then with the box removed you may face a clearance issue with your…

view full answer...

Answer 10

Hey Gene! Mach-C Everest Variable Speed RV AC System #CM35MR will work with your existing furnace. This is a complete replacement so you will install the new rooftop unit, air distribution box, and wall thermostat. The new Coleman thermostat will…

view full answer...

Answer 11

Hey William, so the 3 inch hitches do use the larger hitch pin diameter but the 2-1/2 inch hitches still use the smaller one. So with a reducer like the part #38735 technically you would use both sizes. If you check out the picture I attached you can…

view full answer...

Answer 12

Hey, Joe. That's a great question. Backup cameras and rearview, observation, cameras are essentially the same, the difference comes down to how they’re wired. With a system like the Furrion Vision S+ Wireless RV Backup System #FR57AD, it’s…

view full answer...

Availability of Ball Mount for etrailer High-Low Adjustable Adapter

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching