The bolt hole spacing for the CE Smith Front/Rear Hanger Bracket for Double-Eye Springs #CE14026G is 4-3/8" x 1-5/8". I've attached a dimensional photo for you to check out as well as a review video to reference.
The internal length of u-bolts #SP01-160 is 5-3/4 inches so you would not subtract 9/16 inches from that length. The u-bolt plate #117594-G is 3/16 inches thick. The spring stack for #SP-040275 I just measured and it is 1-7/16 inches thick. Adding in…
It sounds like the U-Bolt Plate #TRTP200175 that you referenced could work for you as this plate is designed for use with 1-3/4 inch wide springs and the other measurements you listed are close. However, I would have you check out the picture I…
A 5200 lb axle is actually a 6000 lb axle that's been de-rated by using a different outer bearing. The proper replacement leaf spring will depend on how long the original springs are. Because leaf springs flatten out and become longer as they…
Hey Mike, thanks for the information! The best weight distribution system for your 7,000 lbs Big Tex 70DM car hauler is going to be the Equal-i-zer item #EQ37100ET. This system works with tongue weights between 600 lbs - 1,000 lbs. That's going…
Thank you for providing all of that information! From the photos and dimensions it looks like you have the suspension kit that's equivalent to the Tandem-Axle Trailer Hanger Kit #APT5. For your axle and hanger spacing you need lead springs that…
Thank you for all of the information and photos - it really helps give me a good idea of what you have/need. The parts that you asked about are listed below but I will say you may need a new axle as well if the location where the current leaf springs…
Based on your images it does appear your trailer was built to have double eye springs rather than a slipper spring. For this you will need to measure your current mounts from bolt hole center to bolt hole center. We have the 3,500LB leaf springs…
For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…
Spring Hanger location dimensions are normally figured by the manufacturer and provided with the spring hanger kit, that includes all of the parts for installing the springs on the trailer frame. I have provided a chart that shows the spring hanger…
Thanks to the information and picture you provided I can definitely help. The replacement for your Dexter 8-248 is the #84545BX. If you want a pre-greased option you can use the #84545UC1-EZ. If you don't care about it being from Dexter the…
Filters
