Result: decals

The 171317 steps are no longer being manufactured, but we do have a replacement gear plate as part #LC301696, motor part #LC301695, and controller part #LC301702.

We have two conversion kits we offer and they will work on either a 2-3/8 inch or 3 inch round axle only. If you have double eye springs, and the axle on your camper measures 2-3/8 inches then part #K71-384-00 would work for you. If you have a 3 inch…

The d-shaped shaft of the Ventline motors is an older style no longer made. You might be able to replace the fan blade you have now as well but I'd need to know diameter of the blades you have.

Based on the pictures I was able to find online that must be 7.5" tall x 5" wide on your 2015 Thor Majestic. Typically when you find a replacement you want to measure the existing cutout to see what would fit. You might be able to use the…

For your 2016 Forest River Cedar Creek, you can take a look at the: -Rubber Wiper Seal and Bulb for RV Slide Out #SR98FR for a wiper seal, and, -The Rubber Bulb Seal for RV Slide Out #SR37FR for a D-Seal. The wiper seal #SR98FR measures 15' Long,…

A trailer light that only has 1 wire means that it grounds through its mounting hardware. The single wire is the power wire. The best surface to ground a light to is steel. If steel is not available in the area the light installs you can attach a…

I sent your axle info to Dexter and they were able to determine that you have a set of 7k Dexter Torflex axles so the correct lift you need is the part #K71-725-02 which will give you a lift of 3-1/8 inches.

I contacted Trimark in regards to a replacement part for the Trimark 030-0900. 030-0900 is actually a series number not a specific part number. To find the part number you will need to take the interior handle completely off the unit. On the back…

The part #RM-910022 is rated for 6,000 lbs so would not be a good choice for your setup that tows a 7,500 lb trailer but the part #C82932 has a 3,300lb safe working load capacity and 16,500lb break strength capacity, which would be way to go.

Those definitely look like Prodigy P2 #90885 troubleshooting codes! You can verify this if the numbers you are seeing are blue. If they are red then this means you have the discontinued Prodigy P1 90185. Regardless of which one you have, the…

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

Hello Mike. The Thetford Toilet Riser - 2-1/2" Tall - White #TH97UE will not work with the Dometic 320 because the base of the toilet is constructed differently, and the toilet sits on top of the Thetford Toilet Riser. If you look at the Dometic…