Search: curt 17499   >  

Yes, a weight distribution system like the Curt TruTrack Weight Distribution System part #C17499 will add stress to both the trailer and vehicle frame. That said, this stress is not usually enough to cause damage. The only exceptions to this would…

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. Measuring is not required if you just take a look at your coupler and see where it attaches to…

You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…

I went ahead and confirmed with my contact at Curt that the spring bars on the Curt TruTrack 2P Weight Distribution System w/ Sway Control - 7-Hole Shank #C69JR are 35" from end to end. I went ahead and attached a diagram of this measurement for…

If you want to install the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C13182 on your 2016 Jeep Grand Cherokee, you will use M14 bolts that are grade 5 as well as compatible flat washers. That is the replacement for what is…

The Sway Bracket Jackets for Equal-i-zer Weight Distribution Systems #EQ95-01-5150 are only designed for use with the Equal-i-zer systems such as the Equal-i-zer Weight #EQ37100ET and should not be used with your Curt TruTrack Weight Distribution…

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

The bars with your current Husky weight distribution system are going to be too heavy duty for your new trailer. Unfortunately, we no longer carry this line from Husky and we will not have the lower rated bars. With that being said, we do have the…

I spoke with my contact at Curt who said that the ideal location for the brackets is 28" on your frame from the hitch ball for the Curt TruTrack #C17499. He did say that they designed this Weight Distribution (WD) system so that you have a…

When the instruction manual for the Curt TruTrack Weight Distribution System part #C17499 states to set the bracket height closest to the spring bar position set with the jack earlier, they are referring to the when you raised the front of the…

It sounds like your system may be overloaded. The first thing I would recommend is finding your actual tongue weight. Your Curt #C79JR (17600) has a tongue weight range of 800-1,000 lbs. If your tongue weight is around 1,000 lbs you're already at…

The best way to pick out a weight distribution system is to based on the loaded tongue weight of your setup when it is fully loaded and ready to go. I would recommend loading your trailer up camper like you are going on a trip and then determining…