Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Mount-n-Lock SafetyStruts Universal Kit #MO34VR includes the Standoff Spacers #MO54VR along with drill bits and the components found in the Standard Kit #MO22FR. The standoff spacers allow for mounting on I-beams shorter than 6".
view full answer...Normally the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR install on outsides of trailer frame. I attached an install video for this for you to check out as well.
view full answer...From how you're describing your set up, it sounds like your bumper is attached to a tube frame, and there is a way for you to install the support brackets, which are the following part number: - Mount-n-Lock SafetyStruts Universal RV…
view full answer...Many RV bumper manufacturers construct their product with a plastic cap or a hinged door instead of endcap, allowing bumper to be used for storage; apparently you have this type. Open that end piece to examine if the seam has spot welds (short…
view full answer...The Safety Struts you have now on your RV frame/bumper would work well with the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 that you mentioned. You can use them instead of the brackets that come with the carrier and you'd be…
view full answer...All of our cargo carriers like the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 you checked out all come with the support brackets. Currently, we do not offer the cargo carrier without the support bracets.
view full answer...Thanks so much for that detailed info, and we do indeed have a trailer hitch for your Jayco trailer with an I-beam frame with a 68 inch inside width, from Curt: - Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide…
view full answer...I do say those welds are bad and it appears the bumper is simply welded onto the back plate of the trailer rather than the frame. I recommend removing the entire bumper for the Mount-n-Lock Heavy-Haul'r Replacement RV Bumper #MNT43VR which…
view full answer...Since your bumper is welded to the frame, it should be very strong and likely won't need to use the support brackets #MO34VR for the 24x60 etrailer Cargo Carrier for RV Bumper #e99049. However, you'll want to verify that the load…
view full answer...If the height of the I-beams is less than 6" as you say then you would have to have to swap out the regular safety struts for the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR, which include spacers to place the…
view full answer...In order to determine the capacity of the rear bumper on any fifth wheel trailer you'll need to reach out to the trailer manufacturer as we don't have this information. That said, it's typically around the 200 lb mark. If you…
view full answer...Yes, the Trailer Bumper Hitch Receiver, part #E-100, can be used on towable pop-up camper units with up to a 4 inch square bumper. However, you cannot exceed the limits of your camper bumper. The bumper towing and tongue capacities may be indicated…
view full answer...Filter Your Search
Contact and Help