Hi Jim, While we do have an adapter for the 7-round on your Ford that will connect to the standard 7-way on your trailer, though not one that is coil type or 3 feet long. The longest one we have is 14-1/2", the Pollak Trailer Connector Adapter -…
Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
Hey Gabby! I think you're looking for the replacement snapper pin / safety pin which is attached to a cable, right? If so, we don't have that part specifically, but we do have universal ones that you can try to match up. You'll want to…
The difference in overall diameter between 4.80-8 and 4.80-12 size trailer tires is about 4-1/2 inches. A smaller tire will clearly not create a clearance issue around fenders where a larger size could. The two tires' widths are fairly close to…
Hi Matt! The #LM48548 inner bearing is typically seen in the AH25555F agricultural hub, but not with an #L44649 outer bearing. This is a very odd hub/spindle you have, especially with that bolt pattern, but I am fairly sure it is a variant of…
Heavy duty ramp springs #RS16933RH and #RS16933LH install on the hinge of the ramp. I have included a picture of what this looks like for you. Not all trailers are exactly the same but this should give you a general idea of how the springs install.
I have attached for you a list of the replacement parts that are available for the Bulldog Powered Drive Trailer Jack part #BD500199. I am not sure which part in particular that you are referring to but if it is not listed below then you would…
The Saf-T-Lube system is similar to the EZ lube spindles that we do carry which allows you to pump grease to the middle of the spindle bearing area through a grease fitting at the end of the spindle. If you look far enough online you'll see…
The key here is that the functions are in the correct locations. Wire color is going to vary from manufacturer to manufacturer which is why you should always wire by function and use a circuit tester like #PTW2992 or #PTW 2993 when wiring in a…
Your 2013 Nissan Titan came from the factory with a quick-connect port under the dash for connection of a brake controller like the Hopkins Agility #HM47294. That quick-connect 4-wire harness for a Hopkins controller is part #HM47635. As long as the…
The only difference in the Demco Channel Tongue Trailer Couplers #DM16080-95 and #DM15931-95 is going to be the bolt pattern. One will have the 5-Bolt hole pattern and the other is going to have 4-Bolt holes. I have included images below showing the…
My contact at Atwood recommended using a pin at least 3/8 in diameter and 2-3/4 inches long. I'd recommend using a snapper pin, part #JFC-PN which has those dimensions.
Filters
