The HydraStar Electric Over Hydraulic Actuator for Disc Brakes - 1,600 psi #HBA16 you were looking at is the correct Electric Over Hydraulic actuator for the disc brakes on your tandem axle boat trailer. You can lock out your Titan Model 10 surge…
Hi Chris! I am not 100% sure why you have two lines going to each brake, but I think that was to daisy chain them together. This was supposed to make bleeding the brakes easier, but I'm not sure if it really did much or not. The Kodiak #KOD59FR…
We do have a great option for replacing your Tie Down LP 750 Brake Actuator. The Dexter DX7.5L A-60 Brake Actuator #DX29FR that you mentioned can be used for a lot of different trailer tongue configurations. It can be slid inside a trailer tongue or…
First, unless the coupler that you have is not functioning properly, does not couple to the ball, or is damaged, you do not have to change it out. It will still function just fine with electric brakes. I went out to the warehouse to determine the…
Hi Steve; first of all no, there are no repair kits since Shelby went out of business years ago. The #DM15000-52 and #12564 can replace it assuming you have a 3" wide channel tongue but you will probably have to drill new holes. We don't…
Thank you for the image. It appears you will need either the Demco Channel Tongue Trailer Coupler #DM13203-95 or #DM16080-95. Both of these couplers have a zinc coating for increased corrosion resistance and fit on a standard 3" wide channel…
There are a number of parts you will need to replace the electric drum brakes on your trailer, and though there is not an all-in-one kit I can let you know the parts you need, starting with a disc brake assembly to replace your current hub and drum.…
We offer the InfiniteRule Hitch Lock for 3" Hitches #34065034 that we know fits and works great to lock the ball mount platform of the BulletProof Hitch #MD206 that you referenced. The span of this is 3-7/8 inches and the diameter is 5/8 inch.
Hi Jason! I pulled one of the Weigh Safe Hitch w/ Built-In Scale for 2" Hitch - 6" Drop/7" Rise - 15K - Steel #WS78RR from our warehouse and the pin (#WS54CR) has 3-7/16" of useable length. With that said, it will fit 2",…
The "Trailer Disconnected" error message on the dash with a factory brake controller is usually related to an issue with the blue brake output wire that runs from the brake controller to the 7-Way connector. The fact that the issue remains…
The big difference between the two couplers you mentioned is that the Demco #DM13205-95 does not come with chain anchors and the part #DM16680-52 does.
LED lights, including LED test lights that can be built into trailer wiring, use so very little power that you do not need to be concerned about depleting your battery. It would take many, many months of continuous draw (without ever running the…
Filters
