Each of the ball positions on the Gen-Y Torsion 2-Ball Mount #325-GH-1325 are separated by 3 inches. So at the very bottom is 9 inches, next up is 6 inches, 3 inches, and then zero drop. In the highest position is 3 inches of rise.
Hey Glenn, the TST TPMS kit you are looking for is the part #TST-507-RV-6-C which is a 6 sensor kit that has standard sensor caps that do not flow through. You'd want to put the signal booster on the motorhome towards the rear.
It sounds like you are looking for a long and low ball mount. BulletProof Hitches Adjustable 2-Ball Mount for 2-1/2" Hitch - 8" Drop/Rise #HD258 is my recommendation for you. From the center of the hitch pin hole to the center of the ball…
We have an adjustable ball mount for you. First, though, the BulletProof Adjustable Ball Mount that you referenced, part #HD258, has only an 8" drop. Unfortunately, that is not enough for your lowest trailer. The top of your receiver to the…
When it comes to picking an adjustable hitch with the best rise/drop for you there are a number of factors to consider. Based on what you looked at, I'm assuming you have a 2-1/2 inch receiver so that starts to narrow it down. You will need to…
After checking some information it appears that the maximum towing capacity of the 2003 Chevrolet 2500 HD is 12,000 lbs. This would be the max and depending on options it may be lower than that. I recommend using the owner's manual to determine…
Since you mentioned needing "at least" 8 inches we'll go ahead and be on the safe side and get you a little more, with a hitch ball mount from BulletProof Hitches that gives you a max of 9-1/4" drop. I'll give you the option…
Hey Braden, good question. Sounds like you’ve got your setup pretty close already. For the most part, you want the trailer riding level or just slightly nose down but no more than about a ½ inch. A little nose down helps keep your weight on the…
There isn't a motor that can be added to the Pro Series Jacks part #PS1400960376. But if you are in the market for that style system, I recommend using #BD182804, and then add motor assembly #BD1824200100. You can also add #BDCS730300 and…
The weight of 1600 gallons of water, without the water tank's own weight factored in, is about 13,350-lbs. For such a high-weight application I suggest Bulldog Square Jacks #BD182804 and #BD182805 along with Connecting Rod #BDCS730300. Two jacks…
The SureShade Power Bimini Top #SS99TR is not going to fit your Seadoo Switch as it requires a rail width of 92-102" wide on center. Your Seadoo Switch has an exteror width of 93.5" putting the rail centers to narrow to fit.
Great question Mark, thanks for the details! Your WFCO WF-8955PEC-GE power center uses a removable converter section and the #WF76FR is the direct replacement main board assembly. It has WFCO's Auto Detect technology, which automatically switches…
Filters
