Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Mike, to use the Yakima StageTwo Bike Rack for 4 Bikes #Y75AR with a 2-1/2 inch hitch will require an adapter like the #e53YR. This is an extension and not a sleeve adapter for the hitch but this will allow you to use the hitch pin setup of the…
view full answer...We do have the Lippert 676062 #LC62FR. This includes the motor and gear box with the link assembly A. If you can provide me with the sticker showing what series steps you have I can verify the correct control unit as well so you that as well.
view full answer...The hanger spacing for the #APT4 with 25-1/8" leaf springs is 27-3/4" on center. I have attached a drawing for your reference.
view full answer...RV air conditioners like the Advent Air RV Air Conditioner w/ Air Distribution Box, Start Capacitor, and Heat Strip #ACM150CH by removing heat from the air inside your RV. The AC unit draws in the hot air, expels heat outside of the RV, and pushes…
view full answer...For the right hand side 18-3/8 inch long equalizer for 2-1/2 inch wide slipper springs you can use #13-140-3. It can actually be used as a left or a right.
view full answer...On a single axle trailer, the shackle straps must be to the rear of the axle, attaching the leaf spring to the spring hanger. This allows the axle to deflect upwards and to the rear if you hit a bump. If the shackle was at the front, the axle…
view full answer...I spoke with my contact at Tekonsha, who is doubtful the controller is the issue. The voltage from the controlleer that's sent to the actuator is very minimal, it's just telling the actuator when and how hard to fire. The actuator is actually…
view full answer...If your Titan BrakeRite #T4813102 is not building pressure you are going to want to start by ensuring the actuator is properly grounded to a 12 volt battery. Should that not be the cause, test the actuator using a voltmeter with the tow vehicle…
view full answer...If you have a factory 4-flat connector or a factory 7-way connector on your 2011 Dodge Ram 1500, the brake controller port will be located underneath the dashboard and to the left of the steering column. It will be taped to another harness near the…
view full answer...The CE Smith Bolster and Swivel Bracket part #CE10000G that you referenced certainly could replace the rusted out brackets on your trailer. This product is designed for doing what you are looking for so it would work well. I attached a review video…
view full answer...The short leg of the CE Smith #CE27648 Post-Style Guide-Ons measures 21-1/2 inches from the end of the leg to the inside edge of the upright and 23 inches to the outside of the upright. I've shown these dimensions in the provided photo. CE Smith…
view full answer...Yes you can install the Hopkins Insight brake controller in your 2021 Ford Ranger and actually you don't need anything else to do so. Your Ranger doesn't have a connector for brake controller wiring and instead has 4 blunt cut wires that are…
view full answer...Filter Your Search
Contact and Help