Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Richard; that's a good question and I think between the two, the best option for use with your Blue Ox tow bar is definitely the Roadmaster option: - Roadmaster Tow Defender #RM-4750 There are a couple reasons I like the Tow Defender…
view full answer...It sounds like you're asking about the deflection of the 2K Timbren Axle-Less Trailer Suspension #ASR2KHDS04, which Timbren has listed as 1-5/8" in the attached diagram - see the (r) label. If you are talking about something else please let…
view full answer...There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…
view full answer...All the brake controller needs to sense a trailer connection so that you can test it is a slight amperage draw on the output circuit. For that you can use a circuit tester like the part #PTW2993 with one pin grounded and the other on the output pin.…
view full answer...I am happy to help with installation, however there is not a plug-in wiring adapter available for your 2016 Jeep Wrangler Unlimited, so you will need to hardwire the controller to the vehicle. It sounds like you already have the brake controller, so…
view full answer...The Roadmaster Sterling #RM-576 is only available with the straight safety cables but we do have the similar Roadmaster Blackhawk #RM-422 which does not have cables so you could use coiled cables like the #RM-653.
view full answer...On the Blue Ox 3 Foot Safety Cables - 10,000 lbs - Qty 2 #BX88208, I reached out to my contact at the manufacturer and the 10,000 lb rating is for each cable. This is not rated on what they are able to tow. They don't have a rating for working…
view full answer...I would be happy to help you get your Tekonsha Prodigy P3 item #90195 installed in your 2011 Chevy Colorado. I linked a video below that shows the brake controller being installed on a 2015 Colorado so you can follow along with the process. Here are…
view full answer...Yes it is that simple! To wire in a brake controller to your 2011 Chevy Colorado only requires you to wire the four wires of the controller to the 4 wires that are present under the dash of your truck. I attached an install video that shows this…
view full answer...According to page 10-46 of the online owner's manual or the 2012 Chevrolet Colorado the Trailer Auxiliary Power Maxi-Fuse (labeled item D in the linked image) is located on top of a wiring harness. You can refer to this image to help you find…
view full answer...The frame not being exposed isn't a big issue since it's just covered up with some corrugated plastic sheeting that can easily be pulled down and cut to fit in accessories. The real issue is going to be with the bumper since it sits right…
view full answer...The Malone paddleboard carrier part #MAL75VR doesn't have a mileage limit and as long as you use it properly it will work, but are there more secure options out there that I would rather recommend...yes. The best option would be the Lockrack part…
view full answer...Related Searches
Filter Your Search
Contact and Help