Available Types of Hand Winches and Maximum Cable Lengths
I’m looking for a hand winch. My most important requirement is maximum capacity on the spool. I use steel cable 3/16 diameter and would like to get about 75 ft on the spool | We have several types of hand winches, including worm gear brake winches...
Recommended Foot with Pin for a 1000 lb Trailer Jack
Is there a leg for a 1000 lb. trailer jack available? The 1000 lb. jack has a smaller diameter than a 2-5000 lb. jack. | A 1,000 lb jack like the A-Frame Trailer Jack - by Dutton-Lainson # DL22530 has a smaller diameter like you stated. This...
Measuring Rise and Length for Drawbars
1) Regarding 1-1/4 inch draw bars, your specs say rise and long length. From where do you measure each of those specifications? 2) Do you sell flat feet for trailer jacks by themselves, I desire to swap the wheel for a flat foot on the trailer...
Comparing the Dutton-Lainson and CE Smith Roller Bunks
Whats the difference between item#DL21741and item#CE27710 | I would be happy to compare the Dutton-Lainson Roller Bunks item # DL21741 and CE Smith Roller Bunks item # CE27710 but there's not that much of a difference. Both are 5 foot long and...
Can You Remove the Case on the Dutton-Lainson StrongArm Electric Winch for Install
I have tapped mounting holes for mounting a winch. Currently have Dutton hand crank winch. Is the cover removable and have clearance to tighten the mounting bolts? | The Dutton-Lainson TW4000 StrongArm Electric Winch part # DL25200 has an access...
Availability of Dutton Lainson # DL22530 Jack in 2000 lb Capacity
Do you have this in a 2 thousand lb jack | We have several different jacks with a 2000 lb capacity that are similar to the Dutton/Lainson jack you referenced, although Dutton Lainson does not offer that particular jack in a 2000 lb capacity...
Worm Gear Hand Winch and Strap to Lift a 50 lb Rooftop Carrier Off of a 2012 Honda Accord
I have a question regarding the Dutton-Lainson Trailer Winch - DL10950 Worm Gear, Regular Drum Handle Drive - 1,500 lb. I am looking for a hand winch that I can wall mount to a joist for raising/lowering a 50 lb rooftop carrier approximately...
Can Dutton Lainson StrongArm Winch be Powered from Battery in Back of Truck
Can I run off opt battery in back of my truck can I hook just to pos and neg to fun the winch | Yes, if you have a battery in the back of your truck you can connect the wires of the Dutton-Lainson TW4000 StrongArm Electric Winch # DL25200 to...
Is Dutton Lainson Hand Winch # DL14881 Designed for Strap or Cable
does the DL14881 WInch require a 3 strap or cable? | The Dutton-Lainson Hand Winch # DL14881 that you referenced is designed to be used with cables like the part # DL24104. |
Recommended Safety Chain Cables For A 2022 Ford F-250 With A BW Hitch
Can you tell me if the safety hooks will fit on a BW Hitch for a 2022 F-250? Is this unlike the Chevy 3500 problem that you responded to previously where the safety hook throat is too shallow? thanks | When it comes to using safety chains...
Can Dutton-Lainson Hand Winch DL14527 Be Freewheeled Or Used In Reverse?
Hello, will does this have a neutral / reverse? I back my boat in with the winch still hooked up, and want it to free spool, but stay strapped. | The Dutton-Lainson Hand Winch # DL14527 you were looking at can be freewheeled to allow you to...
Will the Dutton-Lainson 1802A Bolt Holes Line Up With the 3200A Bolt Holes
I currently have a dl mod.1802a on my boat trailer pulling a 17ft. Lund explorer. will the mod.15440 line up with my current bolt holes/ | The bolt hole spacing as well as the bolt hole pattern is different when you compare the # DL14627 (which...
Dutton-Lainson Quick Connect Electrical Terminals For StrongArm Trailer Winch When Launching Boat
I bought the tw4015 and the quick connect kit. These connections are not waterproof. Will they function properly when the become flooded with water during boat launch and loading? Thank you! | If the Dutton-Lainson Electrical Quick Connect...
Comparing Dutton-Lainson Brake vs Worm Drive Hand Winches
I have a garage application where I need to lift and lower 400 lbs vertically about 6foot through a pulley attached to the ceiling, I am considering something like DL74FRand DL10970 What are the pros and cons of each? | The main benefit of...
Does the Dutton-Lainson Quick Disconnect Winch Harness # DL24151 Include Both Male and Female Ends
Does this winch wiring come with male and female quick disconnects at the rear of the vehicle? The picture shows just one. Thank you for your time. | The Quick Disconnect Wiring Harness you mention, part # DL24151 is designed to plug directly...
Diameter and Height of the Replacement Miter Gear for Dutton-Lainson Trailer Jacks
What is the Dia. and Height of this gear and how many teeth | I went out to the warehouse and measured the gears for the Replacement Miter Gear for the Dutton-Lainson Trailer Jack. The diameter of both gears is 1-1/8 inches. The height of the...
Can Dutton-Lainson Roller Bunk be Attached Directly to Carpeted Bunks on a Boat Trailer
HI. I have 11 foot long bunks on my trailer. They measure 3 inches wide and 5.5 inchs deep not counting the carpet. Can I use 2 sets of the 5 foot long roller bunks and mount then straight to my wooden bunks with lag screws? The boat is...
Reverse Function on the Dutton-Lainson Brake Winch Self-Locking - 2500 Pounds
Hello, I recently purchased this winch from you. Once mounted on my trailer, it seems to be difficult to unwind the cable. I release the handle by turning backwards and cannot pull out the cable by walking it out. Do i have to turn backwards...
Availability of Dutton Lainson Freewheel Brake Winch and Ratchet Handle for DLB-Series Winch
DL has a free wheeling version of the DL15721. It is the DL15761. Do you sell the DL15761? I would have the unit mounted to a portable aluminum base that would be chained back to the inner most D-rings of a toyhauler to bring in a 1000 lb boat...
Winch Recommendation for a PWC Trailer
We have just purchased a Sea doo wake 2015 model along with a dunbier trailer. The dunbier trailer came with a 300kilo winch. On the weekend the winch gave out snapping the pin in the winch and are jet ski came off the trailer smashing the bottom...
Dimensions of Dutton-Lainson Swivel Jack Cap # DL22354
Is this cap 2 1/4inch in diameter? Part number DL22354 | I went into the warehouse to measure the Replacement Trailer Jack Cap for Dutton-Lainson Jacks # DL22354 for you. The outside diameter of this cap is 1.98 inches and the inside diameter...
Recommended Trailer Coupler Locks for Wide Coupler Security
What coupler pin locks both pin style lock and padlock fit this model? The extra width of the coupler latch has made it a bit unique. | For your Atwood Channel Tongue Trailer Coupler 80060, I recommend the Fastway Universal Trailer Coupler...
Plunger Pin Replacement for a Shelby Model 5856A Trailer Jack
I Have a Shelby Model 5856A 1000 lb Trailer Jack and need a replacement plunger pin with 1/2inch pin dia.. I see you have several- will the PLGPIN-12 work on this jack or do I need to go to the DL 22454. There is a price difference and want...
Will Dutton-Lainson Trailer Jack DL22210 Fit 3 x 5 Trailer Frame and Good With Salt Water
Will this Jack go around a 3 inch x 5 inch trailer rail? If not which one would and would survive a salt water marine environment ? My Fulton F2 did not. | The Dutton-Lainson Round Swivel Jack # DL22210 you asked about will fit trailer frames...
Filter Your Search
Contact and Help