Diameter and Height of the Replacement Miter Gear for Dutton-Lainson Trailer Jacks
Updated 03/19/2012 | Published 03/18/2012
Question:
What is the Dia. and Height of this gear and how many teeth
asked by: George N
0
Expert Reply:
I went out to the warehouse and measured the gears for the Replacement Miter Gear for the Dutton-Lainson Trailer Jack. The diameter of both gears is 1-1/8 inches. The height of the taller gear with the circular center is 1/2 inch and the height of the smaller gear is 13/32 inch. Both gears have 12 teeth.
I have included a video that shows the measurements that I took for you.
expert reply by:
John H
0
Product Page this Question was Asked From
Replacement Miter Gear Kit for Dutton-Lainson Trailer Jacks - 600 - 1,000 lbs. (1997 and Newer)
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gears
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Replacement Gears for 1,200 lb Fulton Swivel Jack
- Shop: RV Roof Membrane
- Q&A: Replacement Gear Recommendation for Fulton Trailer Jack
- Shop: Replacement Miter Gear Kit for Dutton-Lainson Trailer Jacks - 1,250 - 2,000 lbs. (1996 and Newer)
- Shop: Replacement Sidewind Gear Kit for etrailer and Ram Square, Direct Weld Jacks - 5,000 or 7,000 lbs
- Shop: Replacement Gear Kit for etrailer and Ram Sidewind Jacks - 2,000 lbs and 5,000 lbs
- Shop: Replacement Gear Kit for etrailer and Ram Round Swivel Marine Jacks - 1,200 lbs and 1,500 lbs
- Shop: Replacement Bevel Gears for HappiJac Truck Camper Jack Systems
- Shop: Replacement Miter Gear Kit for Dutton-Lainson Trailer Jacks - 600 - 1,000 lbs. (1997 and Newer)
- Shop: Replacement Miter Gear Kit for Dutton-Lainson Trailer Jacks - 600 - 1,000 lbs. (1996 - 1997)
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: How To Install the Landing Gear Set Part # RVLG-8000
- Q&A: Replacement Leg for Happijac 4600 Camper Jacks
- Q&A: Replacement Spring-Loaded Landing Gear Drop Leg Pull Pin with 3/8 Inch Diameter
- Q&A: Replacement Landing Gear Spring Loaded Pull Pins For Lippert 2-1/4" Landing Gear With 3/8" Pin
- Article: How to Mount a Truck Bed Camper
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Best Boat Trailer Jacks