Search: ball lock > Wheel Chocks >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Steve! The area you have to trim to install the Curt #C69RJ isn't too big or complicated so it should be pretty simple. See the attached photo. It comes with a diagram to help guide you and I would use a Dremel to make the cut. If you…
view full answer...Hi Bill; are you talking about a hitch where only the receiver is visible at the rear like the #C22HR for the Pilot? This is the same hitch pictured below. The Curt Trailer Hitch Receiver #C69RJ is confirmed to fit your 2026 Honda Passport RTL and…
view full answer...Hey Scott! Your 2026 Ford Ranger may or may not have a brake controller port/plug, even with the tow package. There will be four wires coming out of a large wire harness by the driver side firewall, left of the brake pedal, which can be wired to the…
view full answer...Hello Dan, Wow, that is a really nice camper, Congrats! I’m going to go ahead and say the dealer messed that up. Camper dealers are great at selling campers, but unfortunately, that’s often where their expertise ends. When choosing the right Weight…
view full answer...Hey Jerry, I really like the Tuson Tire Pressure Monitoring System part #335TPMS4WIVS that you referenced. This system replaces the valve stems on the wheels which since you are replacing the tires this would be perfect tire for this. It also is…
view full answer...The 2021 Buick Enclave is pre-wired for a brake controller. If you don't already have a 7-way brake controller, you can install one using part #118287 which would plug into the connector located under the vehicle on the driver's side just…
view full answer...The Optronics LED clearance light that is similar to #MC65RB, but will be amber and red, is the Optronics LED clearance light #MCL65ARB. This light is sealed, waterproof and is a surface mount. The dimensions are 3-15/16 inch length by 1-1/4 inch…
view full answer...The center hole to center hole distance between the hitch pin hole of the Fastway #FA49-00-5600 adjustable ball mount and the holes that the ball platform mounts to is 5-1/8 inches. The distance between the center of the trailer ball and the holes…
view full answer...The Demco Channel Tongue Trailer Coupler #DM16080-81 has a corrosion resistant powder coating that has a 500-hour salt spray rating, so it's been tested to withstand exposure to the elements up to a certain point. On top of the powder coating,…
view full answer...Hey Nicolette, I didn't get the picture but the Demco Channel Tongue Trailer Coupler #DM16080-81 is 16" in overall length and has a 10-1/4" channel length. I measured the mounting holes from the coupler end back and drew up a little…
view full answer...The Curt Adjustable 2-Ball Mount #C45902 is manufactured overseas. If you are looking for a similar made in the USA adjustable ball mount the Flash Solid Steel HD Adjustable 2-Ball Mount #FA49-00-5625 has the same 2-1/2" receiver, 6" drop,…
view full answer...It really depends on the springs used. Take a look at the picture I have included that shows hanger spacing based on several different springs. This will be a good guide to reference when mocking up the suspension on your trailer. This is also found…
view full answer...Filters
- 19 results
Vehicle Fit
Filters
