Search: trailer couplers   >   Accessories and Parts   >   !Lock N Roll  x   >   Frame Bracket  x   >  

The DeeMaxx Disc Brake Kit #DE82FR comes with 2 Slip-on rotors, calipers and brackets for one axle. The slip on rotors are for a 6 on 5-1/2" idler hubs and the mounting brackets fit on a 5 bolt brake flange.

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only…

The Dexter 8-133 axle according to my contact at Dexter is an old motorhome axle they no longer make. Their tech said the motorhome axles like what you have are designed for one time use so there are not compatible parts made for even replacement…

I looked up the information on your TDE 46205 Hubs and found a couple of great replacements for you. The one you pick will depend on the number of wheel studs you have. For 5 wheel studs use the etrailer Trailer Idler Hub Assembly for 2,000-lb E-Z…

First, make sure that you have the correct size Bearing Buddy. It should be slightly larger than the hub bore though it is difficult to tell just by looking. If you can tell me the outer bearing number I can determine which is the correct model.…

Unlike passenger car tires that have a certain range the tire needs to be inflated to, trailer tires should always be kept inflated to the maximum air pressure listed on the sidewall of the tire. We offer the Kenda Karrier 145/80-12 (aka 145/R12) in…

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…

The Dexter 8-283 is an obsolete 2800lb 10 x 1-1/2 inch hub that used a LM67048 inner and a L44649 outer bearing. Unfortunately, we don't have any hubs that would be compatible with the spindles on your axle. Your best bet at this point would be…

Dexter Trailer Springs Over-Under Conversion Kit, part #K71-384-00, is specified by Dexter for use only with double-eye springs. It is not suitable for use with slipper springs. It is considered by our technical friends at Dexter to be unsafe to use…

Since one end of a slipper spring is suspended instead of bolted to a hanger or shackle strap the Dexter Trailer Springs Over-Under Conversion Kit part #K71-385-00 and other likes them are considered unsafe for slipper springs. The only other option…

Yes, I do have the exact dimensions you need of the Demco Channel Tongue Trailer Coupler part #DM15945. I have attached these for you below.

I do have an option for you but I cannot give you exact bearing numbers for your trailer unless provided with spindle measurements or the trailer's VIN (if the manufacturer is still in business). I can however tell you that the two most common…