Search: 47425   >   !Trailer Hubs and Drums   >  

It looks like Trailer Hub and Drum Assembly - 5,200-lb Axles - 6 on 5-1/2 Item #8-201-5UC3 could be the right replacement for you. You can check the bearing numbers if you still have the bearings. If they are 25580 for the inner and LM67048 then…

I confirmed with my contact at Dexter Axle that the grease zerk used in their EZ Lube spindles like #TRU74FR is a standard 1/4-inch pipe thread fitting that you can replace with an item like #Gzerk. Your local hardware store may have one too. You…

The mounting bolt pattern for the Superwinch LT2000 Electric Utility Winch, #1120210, is two holes, 3.15 inches apart. This winch can be mounted in place of a manual winch and my contact at Superwinch assured me that the unit is waterproof so you…

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

The Adapter 6-Pole to 7-Pole Trailer Wiring Adapter #47435 will plug into a 6 round connector on your truck and then convert it to the larger more common 7-pole connector. While the connector is round the terminals inside are mostly blade…

From what I was able to find out from my research, the Tie Down Engineering 11033 hub has a 5 on 4-1/2" bolt pattern and is designed for 3500-lb axles. Replacement hubs that have these specs typically use a #L68149 inner bearing and #L44649…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You need the Wheel Retaining Ring #33-52-1 for your 10K axles and wheels. This ring has the single tab and will allow you to use your current flat faced wheel with Coned Lug Nuts #6-109. The retaining ring will sit outside the the wheels(see image).…

Trailer Wheel Lug Nut - 5/8" #6-109 is 18 threads per inch. It has a 1-1/16" outer diameter, is 90 degree coned and fits 5/8" wheel bolts. TPI is used for standard measurements while pitch is for metric, which is why there isn't a…

Hitch pin and clips like the Curt #C21500 that you referenced don't actually have weight ratings. They are able to withstand the weight ratings of the hitch class they are designed to fit. Since this fits up to Class V trailer hitch receivers it…

Trailer Hitch Pins like the Curt #C21500 do not have specific weight ratings and there is not a database available that will have this type of information. Generally speaking, a 5/8 inch diameter pin, which is designed for Class III, IV and V trailer…

For a replacement clip for your Reese Sway Control System part #83660 you could use the Spring Clip part #55515.