Replacement Hub, Drum and Brake Assemblies for AL KO 3,500 lb Axle
I have a 2008 Flagstaff camper with two Alko axles. It is in need of new brakes/drums. Ive attached a photo of the plate attached to the front axle. Could you reference me to the proper parts, drums and brakes, including seals and dust caps...
Recommended Replacement Hydraulic Pump Motor for a Lippert Leveling System
is the 172911 the replacement for 414850 on a Lippert leveling systems? | Tan, it actually looks like the Replacement Hydraulic Pump Motor for Lippert RV Leveling Systems # LC57AF is the correct replacement for your Lippert 414850. To get...
What Hitch will Have More Clearance the Curt or Draw-Tite on My 2024 Kia EV6?
2024 Kia EV6. Wondering if the Draw-Tite or Curt will end up being lower to the ground? Both 2” hitches. I do not mind cutting a little more plastic. But would like the hitch to be as high as possible. Thanks!! | Hello Kristian, We have only...
Troubleshooting Curt Trutrac System Digging Into Brackets
I recently purchased the Curt Trutrac WD C17501 for my 2004 Ford Excursion towing a 39ft travel trailer. The tongue weight loaded is around 1100 lb. The RV dealership installed the weight distribution on my trailer and set it up but after driving...
Recommended Air Bags for a 2005 Ford Econoline 350 w/ a V10
I have a 2005 Ford Econoline 350 with V10. It has a 3 inch lift. Do you have any rear air suspension products that would work with the lift. I want to tow with it and I am a huge fan of of the rear suspension airbag systems. | Hey Russell, we...
Distance From Ground To Top Of Receiver on Stealth Hitch for 2024 Kia EV6 Wind
What is the the distance from the ground to the top of the hitch on a 2025 Kia EV6 Wind? | Hi Ceemom; according to Stealth Hitches the distance from the ground to the top of the # SH48GR receiver is 9-1/2". What do you plan on using the hitch...
Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire
I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...
What is Max Amperage Draw of Bulldog Winch Light Duty On-Board Air Compressor
What is the maximum amp draw of this compressor? | Hey Michael, the Bulldog Winch Light Duty On-Board Air Compressor # BDW46TJ draws at max just under 40 amps. |
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
What Rack System Can I Use On My 2002 Ford Excursion With Factory Side Tracks
Will this fit the factory tracks of a 2002 ford excursion? | Great question, Dave! After some double checking I can confirm that Rhino Rack part # Y02-480B-NT will work on the factory tracks on the roof of your 2002 Ford Excursion. What are...
Can The Yakima OnRamp Replacement Ramp Be Used For Loading A Trike Into The Back Of A Car?
Can it be used solo to assist in getting my catrike into the back of my ev6? | Hello Cheryl, thanks for reaching out. The Replacement Ramp for Yakima OnRamp Electric Bike Racks # Y99KR might work for that, but keep in mind this is made specifically...
Looking For A Shocker Hitch For My 2003 Ford Excursion Pulling A 7k Trailer
I am interested in a shocker hitch. I have a 2003 ford excursion, 7.3 l diesel with 4 wheel drive. I primarily pull a RV that weighs 7,000 lbs. What model do you recommend? thanks | Hey Patrick, The Shocker Hitch # SHK47VR would be a solid...
Looking For Replacement Weather Stripping For Lift Gate On 2003 Ford Excursion
I need to replace the weather stripping for the lift gate on my 2003 Ford Excursion and the OEM Part 2C7Z-78404A06-AA has been discontinued. I have been searching junk yards and the internet for something that might work. Might you have something...
What To Do When The Air Lift Air Bag Helper Spring Fails During a RV Trip?
I have the 5000 Air Lift series bags on my 2WD Ford Excursion, and during the beginning of our three month RV trip the passenger side will not hold air. Troubleshooting my a local mechanic indicates bag is damaged. What recourse do I have while...
Troubleshooting Open Ground Warning on P3 with Known Solid Ground Connection
I have the Prodigy P3 installed on my 2003 Excursion 6.0L diesel using the 3035-P adapter. Intermittently I get the Open Ground No Brakes warning message. No trailer connected. I checked the batteries negative terminal to chassis in the engine...
Distance from Top of Hitch Opening to Ground for Draw Tite Hitch Kia EV6
What is the resulting receiver height top, interior in inches? | Hey Lenny, when we installed the Draw Tite hitch part # DT85gr on a similar Kia EV6 we found that the top of the hitch opening measured 10-1/2 inches from the ground. |
Recommended Adapter To Connect a 1st Gen Thule Hullavator 897XT To WingBar EVO Crossbars
Hi, I just bought a set of Thule EvoWing bars 711320. I would like to retro fit my older Hullavator TH897xt on them. It was previously installed on square bars and I don’t have any square nuts or flat brackets like I see on most of your videos...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Recommended Factory Replacement Hitch for a 2000 Ford Excursion
2000 Ford Excursion with towing package. The current Ford hitch has an electrical connection in a steel frame to the left of the hitch. I don't see that on the CURT 14011 Class 4 Trailer Hitch. Do I have to remove the current electrical connection...
Are There Any 2025 Kia EV6 Trailer Hitches That Don't Require Cutting Any Trim?
Is there a hitch receiver 2inch or 1¼ that fits a 2025 Kia EV6 that dies not require cutting of any trim? | Hi Steve! All of the hitches that fit your 2025 Kia EV6 will require some cutting of the trim/fascia simply because the whole undercarriage...
Looking for Replacement Locking End Caps for Rhino Rack Aero Roof Rack
hi- i am wondering if rhino rack locking end cap part m622 is available to purchase and what size security key is used to operate. thank you in advance for your time. chris baer | Hey Christopher, it sounds like you are looking for a replacement...
Air Bag and Auto Leveling Compressor kit for 2003 Ford Excursion
Hi. I would like to install air bags on my Excurion 2003 4wd diesel. I would like it to auto level and not have to mess with bicycle pumps etc. Is there a kit for that? Thanks | Hey Pete, we have just what you are looking for with the Firestone...
Replacement Hardware for Draw Tite Hitch that Fits 2022 Kia EV6
Hello, I am in need of the spacers for the trailer hitch for the 2022 EV6 First Edition. Let me know if you have them for sale. Thank you. | We sell replacement hardware for all of the trailer hitches we carry including the part # DT85GR...
Replacement Keys For Rhino Rack
I purchased a Rhino roof rack system 2003 Ford Excursion from you 3 or so years ago. Im in need of replacement keys, the lock number is 012 and the rack end cap is code M622 original keyinch was a blue plastic round key. Can I get those from...
Filter Your Search
Contact and Help