RV Exterior Lights Specs:
Features:
14" x 3-3/4". Low-profile LED utility light produces bright daylight white light to illuminate an interior area. Durable ABS housing and snap-in lens. Surface mount - hardware included. 2-Wire pigtail. 50 LEDs.
More Information >LED Strip Lights Specs:
Features:
22" x 1". Low-profile LED utility light provides bright light to an interior space. Durable polycarbonate housing and lens. Surface mount - hardware not included. 2-Wire design. 27 Diodes.
More Information >Videos
for RV Interior Lights
Help Articles
for RV Interior Lights
Expert Answers
for RV Interior Lights
The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures…
view full answer...A 16 inch tire will not fit on a 16.5 inch wheel. You would either need to get new 16 inch wheels with the proper bolt pattern to match what the hubs require or to get your existing wheels you would need to go with 16.5 inch tires. You mentioned…
view full answer...The temperature light on your Everchill RV Refrigerator w/ Freezer #324-000119 is likely flashing because of a lack of full power to the fridge. The fridge requires 11 amps. It is likely trying to use more power than what is available which is why…
view full answer...I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…
view full answer...National seal 472920 has an inner diameter of 2.25 inches and outer diameter of 3.375. For a replacement, you will want Grease Seal - Double Lip #GS-2250DL or oil seal #10-63.
view full answer...There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…
view full answer...Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what…
view full answer...If you look at the brackets of the TorkLift HiddenPower Under-Vehicle Battery Mount #TLA7727…
view full answer...Yes, you will need the Thule universal change key, #853-1251, to remove and install new lock cores. the change key pulls down all the tumblers so the lock can be removed or inserted. The existing lock, if present, will have to be unlocked for the…
view full answer...If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…
view full answer...The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with…
view full answer...