Parts Needed to Install Electric Brakes On a Tandem Axle Trailer With 3,500 Torque Axles Salt Water
Question:
I bought a used Sport Trail 23foot tandem trailer with torque axles, 3500 lbs each, and no breaks. The boat is 3500 lbs empty and no more than 4500 lbs fueled and loaded. Salt and fresh water exposure. I want to add electric brakes, quality, and economical. What is your advice? I have included pictures of the axle. I also need to replace the electrical wiring with a high-quality harness my truck has a factory brake controller what do you recommend
asked by: Rich H
Helpful Expert Reply:
With your trailer being in an environment where it is exposed to both salt water and fresh water I would highly recommend going with a disc brake setup. There are much fewer components on the brakes to become damaged from the elements with disc brakes. You will need 4 of the DeeMaxx Disc Brake Assemblies # DE89YR with a Hydrastar Electric-Hydraulic Actuator w/ Line Kit # CAR-HBA16-2. You will most likely need a Adapter Module # HBA-CAM for your factory brake controller but be sure to check the chart on the product page to see compatible trucks. Finally a Wiring Kit # HS381-9000 is needed to wire in the electrical with the actuator along with your current trailer light wiring to give you a 7-way connector.
If you prefer to just stay with standard electric brakes you will need 2 of the Electric Brake Kits # AKEBRK-35-SA and 4 of the Hub/Drums # AKHD-545-35-G-EZ-K. You will then need a Junction Box # 3430001-JBK, 7-Way Cord # H20044 and Breakaway Kit # 3802308. You will also need some Wire # 10-1-1 which we sell by the foot to run from the junction box to the brake assemblies. Be sure to use Heat Shrink Butt Connectors # DW05745-5 on any of the wiring which is going to be submerged with the trailer.

Products Referenced in This Question
Junction Box and Installation Kit for Autowbrake Trailer-Mounted Electric Brake Controller
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- Junction Box
- etrailer
more information >
Bright Way Push-to-Test Trailer Breakaway Kit with 1-Amp Charger and 5 Ah Battery - Top Load
- Trailer Breakaway Kit
- Kit with Charger
- Top Load
- Single-axle
- Tandem-axle
- LED Tester
- 1 Amp Charger
- Battery Included
- 5 Ah
- Bright Way
more information >
etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- etrailer
more information >
Hydrastar Electric-Hydraulic Actuator w/ Line Kit for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- Marine
- Travel Trailer
- Disc Brakes
- Hydrastar
more information >
DeeMaxx Single Disc Brake Assembly - 10" Hub/Rotor - 5 on 4-1/2 - Maxx Coating - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 3500 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- DeeMaxx
more information >
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
7-Way Molded Trailer Wire Connector, 6' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 6 - 10 Feet Long
- Plug and Lead
- 7 Round - Blade
- Hopkins
more information >
Hydrastar Electric Over Hydraulic Actuator Adapter Module for Ford and Chevy Brake Controllers
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Adapters
- Hydrastar
more information >
Wiring Kit for Hydrastar Electric Over Hydraulic Actuators
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Wiring
- Hydrastar
more information >
Product Page this Question was Asked From
Easy Grease Trailer Hub/Drum Assembly for 3.5K Axles - 10" Diameter - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Hub with Integrated Drum
- EZ Lube
- L68149 / L44649
- Marine Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Continue Researching
- Shop: DeeMaxx Disc Brake Kit - 10" Rotor - 5 on 4-1/2 - Maxx Coating - 3,500 lbs
- Video: Easy Grease Trailer Hub/Drum Assembly for 3.5K Axles Feature Review
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Galvanized
- Shop: Easy Grease Trailer Hub/Drum Assembly for 3.5K Axles - 10" Diameter - 5 on 4-1/2 - Galvanized
- Video: Easy Grease Trailer Hub/Drum Assembly for 3.5K Axles Review
- Search Results: calkins trailer parts
- Search Results: calkins trailer
- Video: Detailed Breakdown of the etrailer Electric Trailer Brakes
- Shop: Trailer Spindle Nut 1"
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 10" - Left/Right Hand Assemblies - 3.5K
- Q&A: Replacement Hub Recommendation for a Calkins Boat Trailer
- Q&A: Replacement Hubs, Tires, and Wheels for Calkins Boat Trailer with 3,500 Pound Axle
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Shop: Replacement Trailer Hub Bearing - L68149
- Video: Timken Hi-Temp Red Grease for Disc and Drum Brakes Feature Review
- Search Results: grease
- Video: DeeMaxx Disc Brake Kit Review
- Q&A: When Do Brakes Need to be Added to Both Axles of Tandem Axle Trailer
- Q&A: How to Wire Electric Trailer Brakes When Adding 7-Way Connector to Trailer
- Q&A: How to Determine if You Have Manual or Self-Adjusting Brakes
- Q&A: Parts Needed to Add Brakes to 3500 lb Trailer Axle
- Q&A: Are New Brake Drums Required if Replacing Electric Brake Assemblies on a Trailer
- Video: etrailer Easy Grease Trailer Hub and Drums Installation - 2020 K-Z Sportsmen Classic Travel Trailer
- Search Results: trailer hubs and drums
- Video: Detailed Breakdown of the LubriMatic Prime Guard High Temperature Wheel Bearing Grease
- Search Results: bearing grease
- Search Results: trailer grease
- Search Results: deemaxx