Does Factory Hitch Stay Installed When Installing Torklift Hitch # TLD1108-30

Question

Question:

No instructions were shown. Is the Ram factory hitch removed first and the original Ram frame holes reused? Is the factory hitch welded on?

asked by: Steve C

0

Expert Reply:

I attached a link to the install instructions for the Torklift Super Hitch Magnum part # TLD1108-30 that you referenced for you to check out. In it you'll see that the factory hitch of the truck it is installed in does not get removed and the Torklift gets installed below it.

expert reply by: Jameson C

0

Answer 1

We carried over the fit it looks like based on similar hitches from other brands that carried over. It looks like it's a situation where we "know" it fits based on other hitches that do but we haven't gotten the official work from…

view full answer...

Answer 2

The TorkLift Trailer hitch part #TLD1108-30 that you referenced would be exactly what you need. It has a 20k total trailer capacity and 2,500 lb tongue weight capacity.

view full answer...

Answer 3

You are correct, the Torklift hitch part #TLD1108-30 that fits your 2017 Ram 3500 does put a hitch opening below your factory hitch to give you a heavy duty dual hitch setup.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Robert, the Hellwig Rear Anti-Sway Bar #HE83GR (1 1/8"), #HE75YR (1 1/8"; for lifted vehicles 2"), and #HE24MR (1 5/16") will all fit your 2024 Ram 3500. You'd need to measure the diameter of your current sway bars and pick…

view full answer...

Answer 8

Hey Don, Curt does have a Class V hitch for your Ram but it sits super low so it's not going to be what you want. Draw-Tite offers Trailer Hitch Receiver #DT45509. It has a 2-1/2" receiver tube opening, 18,000lb gross towing weight/2,000lb…

view full answer...

Does Factory Hitch Stay Installed When Installing Torklift Hitch # TLD1108-30

Product Page this Question was Asked From

Continue Researching