Measurements of the Bulldog Jack part # BD500187

Question

Question:

Hello, Looking for the measurements on the BD500187. unless they are the same as teh 500185, then i have them from your site Thanks

asked by: James

0

Expert Reply:

Here are some quick measurements of the Bulldog Jack part # BD500187 that you referenced:

Bracket height:
9-3/4" Retracted with footplate retracted
23-3/4" Extended with footplate retracted
31-3/4" Extended with footplate extended

Total travel: 22" Lift: 14"
Drop leg: 8"

Inner tube diameter: 2"
Outer tube diameter: 2-1/4"

I also attached a review video for this jack that shows even more dimensions.

expert reply by: Jameson C

0

Answer 1

When wiring up the Bulldog A-frame trailer jack #BD500187 you can use 12 gauge wire such as #12-1-1 (sold by the foot) as long as the distance from the jack to the battery is less than 20 feet. I am assuming that the battery is located at the front…

view full answer...

Answer 2

I spoke with my contact at Bulldog and the Powered-Drive Trailer Jack, #BD500187, measures 20-1/2 inches from the mounting bracket to the top of the jack. I have included a picture showing this measurement for you.

view full answer...

Answer 3

There are pros and cons to both Husky and Bulldog electric trailer jacks. My favorite Husky jack is the Husky Brute Electric Trailer Jack part #HT87247 and my favorite Bulldog jack is the Bulldog Powered-Drive Trailer Jack part #BD500187. The reason…

view full answer...

Answer 4

The Bulldog Powered-Drive Trailer Jack part #BD500187 has a built-in auto resetting circuit breaker. There isn't a reset procedure for this, since the breaker is thermally operated it will allow power to pass though once the temperature has…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 8

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 9

Hi Scott, thanks for reaching out. A great replacement for the 3,500-lb Lippert jack on your Jayco 32BHDS is the etrailer Electric Trailer Jack – A-Frame – 18" Lift – 3,500 lbs #e23ZV. It’s a bolt-on swap with the same capacity, upgraded…

view full answer...

Measurements of the Bulldog Jack part # BD500187

Featured Help Information

Miscellaneous Media

Continue Researching