Replacement Parts For 7,000 LB Sidewind Trailer Jack

Updated 08/27/2014 | Published 08/25/2014

Question:

I have a Ram 7k sidewind jack on my trailer. Do you not sell Ram brand jacks? Basically mine is welded inside the frame hole was cut in a channel piece and I need to replace the insides. I was just going to by one and then replace all the insides but dont see Ram on your site. Thank you,

asked by: Aaron

Expert Reply:

We do offer several replacement parts for sidewind jacks, however the parts we carry are made for certain manufacturers.

The replacement hardware kit we offer for a 7,000 lb sidewind jack is designed for Bulldog Jacks, and is part # BD500156. This kit includes 3 gears and the pins. Here are the dimensions of the gears included in this kit:
Small gear dimensions
Overall height: 13/16 inch
Overall diameter: 1-7/16 inch
I.D.: 1/2 inch
12 teeth

Large gear with single slot
Overall height: 3/4 inch
Overall diameter: 1-3/4 inch
I.D.: 5/8 inch
16 teeth

Large gear with double slot:
Overall height: 3/4 inch
Overall diameter: 1-3/4 inch
I.D.: 1/2 inch
16 teeth

You can check the dimensions of the gears you need to replace on your jack to see if these match up with the attached photo.

If you decide to replace your jack you can check out the attached product page that lists the sidewind jacks we offer. For a jack with a 7,200 lb weight capacity I recommend part # BD180455. This is a Bulldog Square Jack with a footplate and features a 15 inch lift. This is a weld-on installation, I have attached a product review video for this jack you can check out.